Avocent AutoView AutoView 2020 Quick Installation Manual

Brand: Avocent

Model: AutoView AutoView 2020

Type: Quick Installation Manual

For additional information

For further instructions on AutoView switch connection,

software setup and security configuration, please

refer to the installer/user guide included with the

switch. Check http://register.avocent.com for the

latest AutoView switch software and firmware updates.

Powering up targets and switch

Power up each target server and then power up the

AutoView switch.

The following instructions will help you

to connect your AutoView switch.

Should you require further assistance, please

consult your installer/user guide.

The Power of Being There

To connect a AutoView switch

Quick Installation Guide

AutoView

Switch

AutoView 2020 | AutoView 2030 Switches

Connecting power to the

AutoView switch

Power down all servers that will be part of your

AutoView switching system. Locate the power cord

that came with the AutoView switch. Plug one end

into the power socket on the rear of the AutoView

switch. Plug the other end into an appropriate AC

wall outlet.

Connecting the local port

Plug your VGA monitor, PS/2 or USB keyboard and

mouse cables into the appropriately labeled AutoView

switch ports.

Connecting a AVRIQ module to

the AutoView switch

Choose an available port on the rear of your AutoView

switch. Plug one end of a CAT 5 cable (4-pair, up to

10 meters) into a numbered port and plug the other

end into the RJ-45 connector of a AVRIQ module.

Connecting a server to the

AVRIQ module

Plug the AVRIQ module into the appropriate ports on

the back of the server. Repeat this procedure for all

servers that are to be connected to the AutoView switch.

Connecting network and

remote users

Plug a CAT 5 cable from your Ethernet network into the

LAN connector on the back of your AutoView switch.

Network users will gain access through this port.

Plug in the

keyboard, monitor

and mouse for your

local connection.

Server

Local Connections

Server

Connect network

and remote users.

Connect AVRIQ

modules to the

AutoView switch.

Connect servers to the

AVRIQ modules.

Power down all

servers and attach

the appropriate

power cord to the

AutoView switch.

AutoView Switch

To Contact Avocent Technical Support CALL (888) 793-8763 VISIT www.avocent.com/support DOWNLOAD www.avocent.com

Avocent, the Avocent logo, The Power of Being There and AutoView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. © 2005 Avocent Corporation. All rights reserved. 590-496-001A

Power up target

servers and then the

AutoView switch.

1357

2468

91113

10 12

1357

2468

91113

10 12

Ethernet