2.4G Hz Fix-Gain Booster User Manual
FCC ID: TKZAIB1105G
Copyright:
Copyright © 2008 by AsiaRF. All rights reserved. No part of this publication may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language or computer language, in any form or by any means, electronic, mechanical,
magnetic, optical, chemical, manual or otherwise, without the prior written permission
of AsiaRF.
Under proper usage, products are insured under warranties during a certain amount of
time, excluding any damages induced by human errors. Moreover, AsiaRF reserves the
right to modify in this publication now and then hereof without any obligation to inform
any person of such modification.
All brand and product names appeared in this manual are trademarks and/or registered
trademarks of their respective possessors.
Introduction:
AIB 1105G is a high performing amplifier using Time Division Duplex technology and
operating on 2.4GHz frequency band. It can be installed indoor to increase the strength of
wireless signal and to extend the radio range to a more efficient level. AIB 1105G is
compatible with both 802.11b and 802.11g standards, and can effectively eliminate the
dead spot of your 2.4GHz indoor WLAN.
Limitation Use:
For avoiding damage of the amplifier, installation of the amplifier must be carried
out by a technical installer. And AP must be checked with has obtained
authorization. This access point and amplifier in the system must be used
together with the FCCID: TKZAIB1105G.
Package Includes:
a. Booster SMA female(RP unique connector)/SMA male(RP unique connector)
b. DC Adapter 5V/1.2A
c. Antenna 2dBi
d. User Manual
e. Authorized AP
Installation:
1.Connect the antenna to the SMA male connector of AIB 1105G, the booster
2.Followed by
a. connecting another end of booster, the SMA female connector, of AIB 1105G
to the SMA antenna connector of your AP device, or
b. connecting another end of booster, the SMA female connector, of AIB 1105G to
an external base station, or
c. connecting another end of booster, the SMA female connector of AIB 1105G to
an extra right angle connector, then attach to the SMA antenna connector of your
AP device
3. Connect power adapter to the power socket on AIB 1105G, and plug the other end of
the power pack into an electrical outlet
4.Please refer to the diagram for final assuredness
FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This device must be installed to provide a separation distance of at least 20 cm from all
persons and must not be collocated or operating in conjunction with any other antenna or
transmitter.
NOTE 1: The manufacturer is not responsible for and radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to operate the equipment.
/