PCASKIT100-W ISSUED 12/04/2011 REV0For Technical Support call +44 (0)1923 200 100
Visit Peerless at www.peerless-av.co.uk Page 2 of 4
Do not begin to install your Peerless product until you have •
read and
understood the instructions and warnings contained
in this Installation Manual.
If you have any questions regarding any of the instructions or warnings, please
contact Peerless using the information on the back of this manual.
This product should only be installed by someone of good mechanical •
aptitude, has experience with basic building construction and fully understands
these instructions.
Make sure that the supporting surface is in good condition and will safely •
support the combined load of the equipment and all attached hardware and
components.
Never exceed the Maximum Load Capacity on Page One.•
If mounting to wood stud or joist, make sure that mounting screws are •
anchored into the centre of the studs. Use of an “edge-to-edge” stud f nder is
highly recommended.
If mounting to concrete, breeze block, brick or other masonry material, do not •
drill into mortar joints. Ensure screw and anchor are installed into solid areas
of surface.
Always use an assistant or mechanical lifting equipment to safely lift and •
position equipment.
Tighten screws f rmly, but do not overtighten. Overtightening can damage the •
screws, greatly reducing their holding power.
This product is intended for indoor use only. Use of this product outdoors could •
lead to product failure and personal injury.
This product was designed to be installed on the following surfaces only:•
WALL CONSTRUCTION HARDWARE
7 Concrete, breeze block Included
7 Wood joist Included
7 Other surfaces See Accessories or contact Peerless
Tools Needed for Assembly
Pencil for marking out hole centres •
Electric Drill•
10 mm (3/8”) masonry drill bit for concrete, 5mm (7/32") drill bit for wood joist•
11mm (7/16”) socket wrench for wood screw•
Stud f nder ("edge-to-edge" stud f nder is recommended)•
Installation Screw Pack contents:
WARNING
A
BB
AA
CC
DD
EE
FF
GG
B
D
BB
HH
EE
II
JJ
E
F
G
C
EE) M8 serrated
washer nut
(2)
Parts List
Qty
A Cathedral ceiling plate 1
B 1m pole (length may be different than illustrated) 1
C Bottom tilt bracket 1
D Top tilt bracket 1
E Top Cage 1
F Casio Projector (not included) 1
G Bottom cage 1
AA) 10mm
grey anchor
(4)
BB) M8 x 65mm
security screws
(3)
CC) Split
lock washer
(1)
DD) M8
f at washer
(3)
FF) 5/16” x 3”
wood screw
(4)
GG) M8
shake-proof
washer
(2)
HH) M8 x
15mm security
screw
(1)
II) M3 x 20mm
security screw
(3)
JJ) M4 x 8mm
security screw
(4)
LL) 6” x 1” Allen
Key (1)
KK) 5mm Allen
Key - for use
with DD
(1)