ELECTRIC COUNTER TOP
CHEESEMELTER
OPERATION MANUAL
CMS24Q
CMS24M
CMS24Q Shown
CECILWARE CORPORATION
43-05 20
th
AVENUE, LONG ISLAND CITY, NEW YORK 11105-1295 ■
718-932-1414 FAX 718-932-7860 www.cecilware.com
NN54A 5/05
1
TABLE OF CONTENTS
Introduction ....................................................... page 2
Packaging .......................................................... page 2
Installation ......................................................... page 2
Operation ........................................................... page 2
Cooking By Time ............................................... page 3
Continuous Cooking ......................................... page 3
Cleaning, Care and Maintenance ..................... page 3
Safety ................................................................. page 4
Trouble Shooting .............................................. page 4-5
Compliance ........................................................ page 5
Electrical Diagram ............................................. page 6
Explosion View .................................................. page 7-8
Spare Part List ................................................... page 9
Specifications .................................................... page 10
2
Introduction
Congratulations on the purchase of your Cecilware Cheesemelter. Please take time to carefully read
through this manual to ensure the machine is operated and maintained properly. This will enable the best
possible performance from this product for many years.
Cecilware will not accept liability for the following if:
*The instructions in this manual have not been followed correctly.
*Non-authorized personnel have tampered with the machine.
*Non-original spare parts are used.
*The machine has not been handled and cleaned correctly.
Packaging
Cecilware prides itself on quality and service, ensuring that at the time of packing all products are
supplied fully functioning and free of damage.
Provided in this package are the following:
* Cheesemelter
* Crumb Trays
* Grilling Rack
* Manual
Should you find any damage that has occurred in transit, please contact your Cecilware dealer
immediately.
Installation
Remove the Cecilware Cheesemelter from the packaging. Be certain that all protective plastics and
residues are thoroughly cleaned from its surface.
Place the Cecilware Cheesemelter on a firm level surface.
Local standards and regulations should be consulted in order to abide by standards set in relation to
positioning, spacing, and ventilation.
Caution:
Do not position and operate near combustible materials/flammable objects. Once the Cheesemelter has
been placed in position, ensure the upper and lower stainless steel trays are positioned correctly.
Supply the appropriate power and connect to source. The Cheesemelter is now ready to turn on and
operate. (For power supply, please see technical specification sheet, page 10).
Operation
The Cecilware Cheesemelter has upper and lower elements which can be used together or alternatively;
the top element can be used on its own. This can provide flexibility when toasting and grilling.
The toaster is also fitted with a timer and a thermostat which allows cooking continuously or by time.
Please see next page for further details.
3
Cooking By Time
Select the style of toasting/grilling by selecting both elements or alternatively select the upper element by
pressing the element control switch. Adjust the timer dial to the desired time of cooking. When the time is
selected, the elements will automatically be activated at full power; when the time has lapsed, the
elements will automatically switch off. For this cooking method ensure the thermostat is turned off.
*Note: If the elements are not required to turn off completely, adjust the thermostat dial to low; this will
keep the elements on after the time has lapsed. This will help to keep the product warm and will also
allow for faster reheat when required.
Continuous Cooking
Select the style of toasting/grilling by selecting both elements or alternatively select the upper element by
pressing the element control switch.
When cooking continuously, be sure the timer dial is turned off. Using the thermostat dial, select the
desired temperature. When selected, the elements will automatically switch on; when finished, turn the
thermostat dial off. The timer will over ride the energy regulator if it is not turned off.
*Summary: Time Control - provides full power to elements for the selected period of time.
The thermostat control provides the desired heat control setting for continuous operation when the timer
is off.
*Note: When in operation, the Cheesemelter will be hot; part of unit is the grilling rack which is handled
regularly. This rack is made from steel and will hold heat; therefore, protective gloves must be worn for
protection when handling.
Cleaning, Care and Maintenance
Switch off the power and disconnect from the power source.
The Cheesemelter should be cleaned after each day’s operation; however, the unit may require more
frequent cleaning, depending on the volume of production.
Allow the Cheesemelter to cool before cleaning. Remove upper and lower trays and wash them in
warm soapy water; be sure to dry before returning them to the unit.
The remainder of the Cheesemelter can be cleaned with a damp cloth using hot, soapy water.
Do not immerse completely in water or use hose to clean.
Warm soapy water is recommended for cleaning; prolonged use of cleaning agents may cause damage
to stainless steel.
4
Safety
Cecilware Qualified Service Technician should carry out repairs if necessary. Do not remove any
components or service panels on this product
When cleaning, switch power off and disconnect from the outlet. If the power cord is damaged, it must
be replaced by a Cecilware Recommended Qualified Service Technician in order to avoid a hazard.
Allow the Cheesemelter to cool down after use before dismantling for cleaning; the unit will still be too hot
to handle immediately after use.
Trouble Shooting
If your Cecilware Cheesemelter does not operate, please check the following before placing a service
call.
Top Cheesemelter
CMS24Q, CMS24M
Problem Cause Remedy
1. Mains power supply 1. Check mains power supply
2. Unit is not switched on
2. Check that the unit is correctly
plugged in and turned on;
ensure you have read the
manual for both methods of
operation:
¾ Timer Control: provides full
power to the elements for the
period of time selected
¾ Dial Control: provides desired
heat for continued operation when
the timer is off
3. Fuse in the plug has
blown
3. Replace the fuse in the plug with
correctly rated fuse
4. Dial Control or Timer
are faulty
4. Call service agent or qualified
technician
5. Plug and lead are
damaged
5. Call service agent or qualified
technician
The unit is not working, the
indicator light is not on.
6. Internal wiring fault
6. Call service agent or qualified
technician
The unit is heating but the
indicator lights are not on.
1. The indicator light is
faulty
1. Call service agent or qualified
technician
Trouble Shooting Cont…
Problem Cause Remedy
1. Incorrect operation
1. Ensure that you have clearly
read the manual, fully taking into
account whether the unit has
been selected for Timer Control
or for Dial Control and also
whether single or double
element heating has been
selected
2. Elements are faulty
2. Call service agent or qualified
technician
Slow heat up or no heat
up, power is on.
3. Power dial is faulty
3. Call service agent or qualified
technician
Please ensure:
* There is correct power supply.
* The machine is plugged in correctly and power is switched on.
* The timer and thermostat are in the correct position.
* The elements are clear of any food waste.
Note: All Cecilware products are tested prior to packing.
Compliance
Cecilware products have undergone strict product testing in order to comply with regulatory standards
and specifications set by international, independent, and federal authorities.
As testimony to such compliance, Cecilware products carry the following marks/symbols:
5
Electrical Diagram
Model: CMS24Q
on/off
switch
L
240V
N
E
L
LOAD
N
PILOT
timer
thermostat
pilot light
top elements
selector
switch
pilot light
CMS24M
o
n/off
s
witch
pilot light
thermostat
pilot light
PILOT
N
LOAD
L
E
N
240V
The above circuit diagram has been provided to assist qualified technicians. A Recommended Qualified
Service Technician should carry out repairs if needed. Do not remove any components or service
panels on this product.
6
Explosion View
CMS24M
7
8
9
5
7
6
11
12
14
13
15
2
10
4
1
3
16
CMS24Q
8
9
8
10
7
13
11
12
14
15
6
5
4
2
3
16
1
9
Spare Parts List
NO. DESCRIPTION QTY Part NO.
HEATING ELEMENT (METAL) 8 08010
1
HEATING ELEMENT (QUARTZ) 6 08019
2 CORD & PLUG 1 08047
3 SIDE PANEL 2 NA
4 INSULATION 2 NA
5 INSULATION CLAMP 1 NA
6 FEET 4 08031
7 BASE PLATE 1 NA
8 ENERGY SWITCH 1 08011
9 DIAL 2 08012
10 TIMER 1 08013
11 HEATING SELECTION SWITCH 1 08014
12 PILOT LIGHT 2 08015
13 ON/OFF SWITCH 1 08054
14 GRILL RACK 1 08016
15 CRUMB TRAY 2 08039
16 CERAMIC TUBE 8 08077
*NA = not available except by special order.
10
Specifications
CECILWARE
MODEL
VOLTAGE
POWER
(Watts)
DIMENSIONS (INCHES)
W×D×H
ELEMENT
CMS24Q 2400 23 1/2”×13 1/4”×12 3/4” QUARTZ
CMS24M
240V
~
50/60HZ
2400 23 1/2”×13 1/4”×12 3/4” METAL
CECILWARE CORPORATION
43-05 20
th
AVENUE, LONG ISLAND CITY, NEW YORK 11105-1295 ■
718-932-1414 FAX 718-932-7860 www.cecilware.com
11
/