Operation manual
Portable Waterproof Voice Amplifier
▌
IN THE BOX
Headset microphone, strap, switching power supply (100-240V AC, 12V
DC 1A) and operation manual.
※Specifications are subject to change without prior notice.
▌
PARTS AND FUNCTIONS
Master power button
Bluetooth power button
Volume down button
Volume up button
Power / battery low
indicator
Bluetooth power/pairing
indicator
Battery cover
Rotary clip
Counterclockwise 45°to stand
▌
OPERATING PROCEDURES
To operate this voice amplifier, turn on the main power switch and the
power indicator will be GREEN and you will hear a voice ‘POWER ON’. If
it turns RED, its battery power is lower than 20% and recharging is
necessary. The amplifier can still operate during charging process
There is a MIC IN jack with volume controls on this voice amplifier. To use
a headset microphone, just insert its phone plug into the MIC IN jack.
Then turn on the amplifier and then adjust the volume by & buttons.
▌
CONNECTING TO EXTERNAL AUDIO
▌
BATTERY REPLACEMENT
Rotate to remove the clip
Remove the cover
Insert four AA batteries
MUSIC
x4
Connect your device
to the amplifier’s
AUX IN jack with a
3.5mm cable.
Turn on the amplifier
and use the &
buttons to adjust the
volume.
Phone, PC, tablet,.etc.
▌
CONNECTING BLUETOOTH (optional)
Turn on the amplifier
Press and hold the
button to turn on the
Bluetooth. You will hear
‘POWER ON’ and the
pairing indicator will
flash green.
Press and hold the button
to activate pairing. You will
hear ‘READY TO PAIR’
and the pairing indicator
will flash green and red.
Activate Bluetooth on
your device (phone,
tablet, PC..,etc) and pair
with external Bluetooth
device named ‘BT
AUDIO’.
After successful linking, you
will hear ‘PAIR COMPLETED.
DEVICE CONNECTED’ and
the pairing indicator will glow
green and you can play your
music on iTour.
Use
the &
buttons to adjust
the volume.
※
iTour’s Bluetooth automatically turns off after disconnection for 3 minutes. It
can also connect to last paired device automatically. Press the BT button to end
connection for standby or new pairing/connection.
DEVICES
BT AUDIO
Now Discoverable
...
▌
IMPORTANT SAFETY INSTRUCTIONS
Please read and follow the instructions in this manual thoroughly to obtain
optimum results from this unit. We also recommend that you keep this
manual handy for future reference.
Recharge for about 4~6 hours before operation when using NiMH
batteries.
DO use offered switching adaptor (100-240V AC, 12V DC 1A) to avoid
damages to the product.
DO NOT expose the product to heat sources or inflammables during
charging.
During charging, the charging indicator will flash RED. When this LED
turns GREEN, this battery is then fully charged. After removing the power
supply, the LED will turn off automatically.
Battery should be fully charged after every use or every three months.
This product has protection circuit, ready to charge anytime.
When the power LED turns ORANGE, the battery power is lower then
20% and need to be charged.
※To avoid feedback, DO NOT face the microphone to the speaker.
CHIAYO ELECTRONICS CO.,LTD.
Http://www.chiayo.com.tw
｜
Email: sale[email protected]
Office: 30, Lane 27, Section 4, Jen-Ai Road, Taipei 10685, Taiwan
Tel: 886-2-27415741
｜
Fax: 886-2-27525242
Factory: 88, Chung-Hsiao Street 2, Chiayi 60080, Taiwan
Tel: 886-5-2711000
｜
Fax: 886-5-5767611
/
