Installation instructions
Oven / Combi-Steam oven
Type of construction 60-600
J731.113-0
1.10.08 ITH
1
These installation instructions apply to the models:
Identification plate
A Open appliance door. The identification plate is located on the left trim panel
(see illustration).
Connection plate
A Pivot connection box downwards. The connection plate is located next to the
connection terminal in the connection box (see «Installation»).
A Information on the necessary mains voltage, type of current and fuse protection is to be obtained from the identification plate.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
Oven:
Combi-Steam oven:
731, 734, 739, 740, 745, 747, 751, 759, 764, 765
771, 796
General notes
If fitting in flammable material, the guidelines and standards for low voltage installations and for the fire protection must be strict-
ly observed.
Electrical connections
Electrical connections must be carried out by trained electricians in accordance with the guidelines and standards for low volt-
age installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are per-
missible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation. After installation, live parts and cables with basic insulation must not be accessible. Old installations should al-
ways be checked.
Installation instructions
Oven / Combi-Steam oven
Type of construction 60-600
J731.113-0
1.10.08 ITH
2
Installing for a niche height of 600 mm
1. Slide appliance approx. 19 cm into the niche. Caution: danger of tipping over!
2. Pivot connection box D downwards after loosening screw S1.
3. Draw connection cable H from the point where it leaves the wall and through hole L and press firmly on snap lock E to secure the
strain relief.
4. Connect connection cable to connecting terminal G in accordance with connection plate F.
5. Pivot connection box D upwards and fasten with screw S1.
6. Slide appliance into the niche until flush with the front and fasten the sides from the front with the 4 enclosed screws S2.
Installing variant for a niche height of 635 mm with adapter frame (see J731.050)
Installation
Open snap lock E for the strain relief using screwdriver.
=
=
30
min. 550
600
560–568
594
20
X
548
548
S2
598
S2
~45
(567)
440
D
E
S1
G
L
F
~16˚
~85˚
596
H
594
Niche
598
Appliance
Detail X
D Connection box
E Snap lock
F Connection plate
G Connection terminal
H Connection cable
L Hole for connection cable
S1 Screw for connection box
S2 Fastening screws (4×)
598
596
=
=
30
min. 550
600
560–568
635
20
(567)
548
596
480
35
560
548
19.5
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
EURO EDM15WH Owner's manual
-
Zanussi ZOB65301XK User manual
-
York ECO R-407C User manual
-
Dish Network Platinum Plus 121150 User manual
-
-
Electrolux EB4GL90CN User manual
-
-
-
-
Zanussi ZEI6840FBA Datasheet