2 of 2
ISSUED: 06-14-10 SHEET #: 120-9089-1
Hook cable management bracket (A) onto wall plate (SOLD SEPARATELY) and slowly swing down as shown in gure
1.1. Hand thread two M5 x 25 mm socket pin screws (B) through cable management bracket (A). Using 4 mm allen
wrench (SUPPLIDED WITH WALL PLATE), turn screws clockwise until screw tip securely contacts wall plate as shown in
gure 1.2.
NOTE: Displays may need to be removed in order to access center of wall plate (SOLD SEPARATELY).
Cables can be secured to cable management bracket (A) using cable ties (C) as shown below.
1
Attaching Cable Management Bracket
g 1.2
g 1.1
A
B
A
C
A
1-1
CABLES
© 2010, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
WALL PLATE
(SOLD SEPARATELY)
WALL PLATE
(SOLD SEPARATELY)