DPA 4018 Supercardioid Microphone User guide

DPA
Brand
DPA
Model
4018 Supercardioid Microphone
Category
Microphones
Type
User guide

DPA 4018 Supercardioid Microphone is a high-quality microphone designed for professional audio applications. It features a supercardioid polar pattern, which provides excellent directivity and off-axis rejection, making it ideal for use in noisy environments or when isolating a specific sound source. The microphone has a wide frequency response of 10 Hz to 20 kHz, making it suitable for capturing a wide range of audio sources, from vocals to instruments. It also has a high sensitivity of 12 mV/Pa, which allows it to capture even the quietest sounds.

The DPA 4018 Supercardioid Microphone is a versatile microphone that can be used in a variety of applications, including:

DPA 4018 Supercardioid Microphone is a high-quality microphone designed for professional audio applications. It features a supercardioid polar pattern, which provides excellent directivity and off-axis rejection, making it ideal for use in noisy environments or when isolating a specific sound source. The microphone has a wide frequency response of 10 Hz to 20 kHz, making it suitable for capturing a wide range of audio sources, from vocals to instruments. It also has a high sensitivity of 12 mV/Pa, which allows it to capture even the quietest sounds.

The DPA 4018 Supercardioid Microphone is a versatile microphone that can be used in a variety of applications, including:

d:dicate™ 4018A Supercardioid Microphone
A combination of the MMC4018 Microphone Capsule and the MMP-A
Preamplifier, this mic is part of the modular d:dicate™ Recording Micro-
phones series. At any time and with no tools necessary it is transform
the basic 4018A Microphone into a new configuration by combining it
with another d:dicate™ Microphone Capsule or Preamplifier.
Performance
Mount the foam windscreen on the mic head whenever used outdoors
or in air turbulent situations such as close miking voice in order to
prevent wind or pop noise.
With each d:dicate™ Microphone Capsule, comes a unique calibration
chart that shows the exact frequency response of the purchased
capsule measured with a linear MMP-A Preamplifier.
Typical on- and off-axis and frequency responses for a MMC4018 at
30 cm (1ft):
Attenuation pad
The MMP-A Preamplifier has a 20 dB attenuation push-
switch at the XLR connector. Use a pencil or the like
to activate the attenuator and lower output by 20 dB.
DPI-4015C-QG
Service & repair
-J]SYEVIRSXWEXMW½IH[MXLXLIGLEVEGXIVMWXMGWI\LMFMXIHF]XLMWTVSHYGXTPIEWIGSRXEGX]SYVRIEVIWX(4%
Microphones representative for support.
Warranty
'MWGSZIVIHF]E½ZI]IEVPMQMXIH[EVVERX]
CE marking
8LMWTVSHYGXGSRJSVQW[MXLEPPVIPIZERXHMVIGXMZIWETTVSZIHF]XLI)YVSTIER'SQQMWWMSR
4018A Supercardioid Microphone
A combination of the MMC4018 mic capsule and the MMP-A
preamplifi er, the 4018A supercardioid mic is part of the modular DPA
d:dicate™ Recording Microphones series. At any time and with no
tools necessary it is transform the basic 4018A microphone into a new
confi guration by combining it with another DPA microphone capsule
or preamp.
PERFORMANCE
Mount the foam windscreen on the mic head whenever used outdoors
or in air turbulent situations such as close miking voice in order to
prevent wind- or pop noise.
With each DPA microphone capsule, comes a unique calibration chart
that shows the exact frequency response of the purchased capsule
measured with a linear MMP-A preamp.
Typical on- and off-axis frequency responses for a MMC4018 at 30
cm (1 ft):
ATTENUATION PAD
The MMP-A preamplifi er has a 20 dB attenuation push-switch at the
XLR output connector. Use a pencil or the like to activate the attenua-
tor and lower output by 20 dB.
dB
10
0
- 10
-20
-30
20 Hz 50 100 200 500 1 kHz 2 5 10 20 40
90
14 0
0
30
60
w w w . d p a m i c r o p h o n e s . c o m / 4 0 1 8
4018A is covered by fi ve-year limited warranty.
DPI-4018A-QG
d p a m i c r o p h o n e s . c o m / 4 0 1 8 A
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please go to
www.dpamicrophones.com/service for instructions.
Warranty
The d:dicate™ 4018A Supercardioid Microphone is covered by a five-year limited warranty.
CE marking
This product conforms to all relevant directives approved by the European Commision.
DPI-4018A-QG
2011A Cardioid Microphone
A combination of the MMC2011 mic capsule and the MMP-A preamp,
the 2011A is part of the modular DPA Reference Standard series.
ATTENUATION PAD
8LI114%TVIEQTPM½IVLEWEH&EXXIRYEXMSRTYWL
switch at the XLR connector. Use a pencil or the like to
EGXMZEXIXLIEXXIRYEXSVERHPS[IVSYXTYXF]H&
Service & repair
-J]SYEVIRSXWEXMW½IH[MXLXLIGLEVEGXIVMWXMGWI\LMFMXIHF]XLMWTVSHYGXTPIEWIGSRXEGX]SYVRIEVIWX(4%
Microphones representative for support.
Warranty
2011A is covered by a two-year limited warranty.
CE marking
This product conforms with all relevant directives approved by the European Commission.
www.dpamicrophones.com/2011A
DPI-2011A-QG
2011A Quick Guide.indd 1 30/11/11 09.23
7TIGM½GEXMSRW
Directional pattern
Wide cardioid
Principle of operation
4VIWWYVIKVEHMIRX
'ETWYPIX]TI
Pre-polarized condenser
*VIUYIRG]VERKI
20 Hz to 20 kHz
*VIUYIRG]VERKIH&
40 Hz to 20 kHz
7IRWMXMZMX]RSQMREPH&EXO,^
Q:4EH&VI:4E
)UYMZEPIRXRSMWIPIZIP%[IMKLXIH
8]TH&%VIµ4EQE\H&
3YXTYXMQTIHERGI
< 200 ohm
3YXTYXFEPERGITVMRGMTPI
-QTIHERGIFEPERGMRK[MXL%GXMZI(VMZI
Common Mode Rejection Ratio (CMRR)
"H&
4S[IVWYTTP]
:4LERXSQTS[IV:
'YVVIRXGSRWYQTXMSR
Q%
Polarity
:EX4MRJSVTSWMXMZIWSYRHTVIWWYVI
Connector
<0614MRWLMIPH4MRWMKREPTLEWI4MRTLEWI
Weight
KS^
3TIVEXMRKXIQTIVEXYVIVERKI
'XS'*XS*
6IPEXMZILYQMHMX]
Up to 90%
Directional pattern
Supercardioid
Principle of operation
Pressure gradient
Cartridge type
Pre-polarized condenser
Frequency range
10 Hz - 20 kHz
Frequency range, ± 2 dB, at 30 cm
40 Hz - 18 kHz
Sensitivity, nominal, ±2 dB at 1 Hz
12 mV/Pa; -38.4 dB re. 1 V/Pa
Equivalent noise level, A-weighted
Typ. 16 dB(A) re. 20 µPa (max. 19 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL)
Typ. 78 dB(A)
Total Harmonic Distortion (THD)
< 1 % up to 137 dB SPL peak
Dynamic range
Typ. 121 dB
Max. SPL, peak before clipping
157 dB
Switchable attenuator, filters etc.
0 dB / -20 dB
Output impedance
200 Ω
Minimum load impedance
2 kΩ
Cable drive capability
100 m (328 ft)
Output balance principle
Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR)
> 60 dB
Power supply
48 V Phantom power (±4 V)
Current consumption
2.8 mA
Connector
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color
Matte black
Weight
158 g (5.6 oz)
Microphone diameter
19 mm (0.75 in)
Capsule diameter
19 mm (0.75 in)
Microphone length
170 mm (6.7 in)
Maximum output voltage, RMS
7 V
Polarity
+V at Pin 2 for positive sound pressure
Temperature range
-40 to 45 °C (-40 to 113 °F)
Relative Humidity (RH)
Up to 90%
  • Page 1 1
  • Page 2 2

DPA 4018 Supercardioid Microphone User guide

DPA
Brand
DPA
Model
4018 Supercardioid Microphone
Category
Microphones
Type
User guide

DPA 4018 Supercardioid Microphone is a high-quality microphone designed for professional audio applications. It features a supercardioid polar pattern, which provides excellent directivity and off-axis rejection, making it ideal for use in noisy environments or when isolating a specific sound source. The microphone has a wide frequency response of 10 Hz to 20 kHz, making it suitable for capturing a wide range of audio sources, from vocals to instruments. It also has a high sensitivity of 12 mV/Pa, which allows it to capture even the quietest sounds.

The DPA 4018 Supercardioid Microphone is a versatile microphone that can be used in a variety of applications, including:

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents