d:dicate™ 4018A Supercardioid Microphone
A combination of the MMC4018 Microphone Capsule and the MMP-A
Preamplifier, this mic is part of the modular d:dicate™ Recording Micro-
phones series. At any time and with no tools necessary it is transform
the basic 4018A Microphone into a new configuration by combining it
with another d:dicate™ Microphone Capsule or Preamplifier.
Performance
Mount the foam windscreen on the mic head whenever used outdoors
or in air turbulent situations such as close miking voice in order to
prevent wind or pop noise.
With each d:dicate™ Microphone Capsule, comes a unique calibration
chart that shows the exact frequency response of the purchased
capsule measured with a linear MMP-A Preamplifier.
Typical on- and off-axis and frequency responses for a MMC4018 at
30 cm (1ft):
Attenuation pad
The MMP-A Preamplifier has a 20 dB attenuation push-
switch at the XLR connector. Use a pencil or the like
to activate the attenuator and lower output by 20 dB.
DPI-4015C-QG
Service & repair
-J]SYEVIRSXWEXMW½IH[MXLXLIGLEVEGXIVMWXMGWI\LMFMXIHF]XLMWTVSHYGXTPIEWIGSRXEGX]SYVRIEVIWX(4%
Microphones representative for support.
Warranty
'MWGSZIVIHF]E½ZI]IEVPMQMXIH[EVVERX]
CE marking
8LMWTVSHYGXGSRJSVQW[MXLEPPVIPIZERXHMVIGXMZIWETTVSZIHF]XLI)YVSTIER'SQQMWWMSR
4018A Supercardioid Microphone
A combination of the MMC4018 mic capsule and the MMP-A
preamplifi er, the 4018A supercardioid mic is part of the modular DPA
d:dicate™ Recording Microphones series. At any time and with no
tools necessary it is transform the basic 4018A microphone into a new
confi guration by combining it with another DPA microphone capsule
or preamp.
PERFORMANCE
Mount the foam windscreen on the mic head whenever used outdoors
or in air turbulent situations such as close miking voice in order to
prevent wind- or pop noise.
With each DPA microphone capsule, comes a unique calibration chart
that shows the exact frequency response of the purchased capsule
measured with a linear MMP-A preamp.
Typical on- and off-axis frequency responses for a MMC4018 at 30
cm (1 ft):
ATTENUATION PAD
The MMP-A preamplifi er has a 20 dB attenuation push-switch at the
XLR output connector. Use a pencil or the like to activate the attenua-
tor and lower output by 20 dB.
dB
10
0
- 10
-20
-30
20 Hz 50 100 200 500 1 kHz 2 5 10 20 40
90
14 0
0
30
60
w w w . d p a m i c r o p h o n e s . c o m / 4 0 1 8
4018A is covered by fi ve-year limited warranty.
DPI-4018A-QG
d p a m i c r o p h o n e s . c o m / 4 0 1 8 A
Service & repair
If you are not satisfied with the characteristics exhibited by this product, please go to
www.dpamicrophones.com/service for instructions.
Warranty
The d:dicate™ 4018A Supercardioid Microphone is covered by a five-year limited warranty.
CE marking
This product conforms to all relevant directives approved by the European Commision.
DPI-4018A-QG
2011A Cardioid Microphone
A combination of the MMC2011 mic capsule and the MMP-A preamp,
the 2011A is part of the modular DPA Reference Standard series.
ATTENUATION PAD
8LI114%TVIEQTPM½IVLEWEH&EXXIRYEXMSRTYWL
switch at the XLR connector. Use a pencil or the like to
EGXMZEXIXLIEXXIRYEXSVERHPS[IVSYXTYXF]H&
Service & repair
-J]SYEVIRSXWEXMW½IH[MXLXLIGLEVEGXIVMWXMGWI\LMFMXIHF]XLMWTVSHYGXTPIEWIGSRXEGX]SYVRIEVIWX(4%
Microphones representative for support.
Warranty
2011A is covered by a two-year limited warranty.
CE marking
This product conforms with all relevant directives approved by the European Commission.
www.dpamicrophones.com/2011A
DPI-2011A-QG
2011A Quick Guide.indd 1 30/11/11 09.23