Installation Instruction
1. Remove the suction pad cover
2. Place the mount on the desired surface and pull down the lever to secure the mount
3. Open the One Touch Locking Arm
4. Press button in back of the mount to lower bottom foot
5. Place the device in mount and raise the bottom foot by pressing the button in the back.
6. Line device up with line located on the one touch locking arm
7. Press device with one finger to activate the one touch locking arm which will securely lock
your device into place
8. Loosen knob to extend telescopic arm to desired length
9. Adjust Cradle in angle with ball pivot joint
Additional Information
1. Assemble the neck and base parts securely by mount adjusting knob
2. Insert the Mount into the Connector, pull up to lock
3. Add stopper to the bottom of the connector to prevent mount from disconnecting when placing
tablet into mount
-
1
-
2
-
3
-
4
-
5
-
6
