LT-6161 Rev 2 2020-02-04 Page 1 of 2
BB-1001WP(R)A and BB-1002WP(R)A Weather
Protected Enclosures
Rated for Outdoor Environment Wet Location according to UL 864 and ULC-S527
122 °F (+50 °C) to −40 °F (−40 °C)
BB-1001WP(R)A
Notes: BB-1001WPA is a white model. BB-1001WPRA is a red model.
Connect chassis ground stud to earth ground.
To prevent water from entering the box:
• Use a threaded conduit connector to provide entry for cables.
• Apply outdoor-rated weatherproof silicone to the 4 mounting holes and around the
threaded conduit connector.
Refer to RAM-1032TZDS in LT-617 RA-1000 Series Manual for wiring instructions, DIP switch
settings, and operation.
11 5/32”
13/16”
12 15/16”
Diameter 7/32”
11”
9 1/2”
3 1/2”
Use 1 of the 2 knockouts for wiring.
Diameter of knockouts: 7/8”
Threaded conduit
connector (eld installed)
Suggested location
Apply outdoor-rated
weatherproof silicone
to the 4 mounting
holes and around the
threaded conduit
connector.
Door
Backbox
Annunciator
(RAM-1032TZDS-CC shown)
GB-1001RAM guard bracket
for RAM-1032TZDS-CC
4 nuts
LT-6161 Rev 2 2020-02-04 Page 2 of 2
BB-1002WP(R)A
Notes: BB-1002WPA is a white model. BB-1002WPRA is a red model.
Connect chassis ground stud to earth ground.
To prevent water from entering the box:
• Use a threaded conduit connector to provide entry for cables.
• Apply outdoor-rated weatherproof silicone to the 4 mounting holes and around the
threaded conduit connector.
Refer to RAM-1032TZDS and RAX-1048TZDS in LT-617 RA-1000 Series Manual for wiring
instructions, DIP switch settings, and operation.
17 15/16”
13/16”
Diameter 7/32”
12 15/16”
11”
16 5/16”
3 1/2”
Door
Backbox
RAX-1048TZDS-CC
RAM-1032TZDS-CC
GB-1001RAM guard bracket
for RAM-1032TZDS-CC
4 nuts for top annunciator
4 nuts for bottom annunciator
Use 1 of the 3 knockouts for wiring.
Diameter of knockouts: 7/8”
Threaded conduit
connector (eld installed)
Suggested location
Apply outdoor-rated
weatherproof silicone
to the 4 mounting
holes and around the
threaded conduit
connector.
/
