Active Holder
for Fixed Installation
The neatest installation
An active holder with a straight cable with
open end for fixed installation and a cable with
Molex adapter system. The cables are to be
connected inside the dashboard, this gives a
discreet, neat installation without cables hang-
ing over the interior.
You can choose to use the holder as an active
holder only for charging, or to connect an
adapter to the Molex connector for additional
features. Then you can use the holder also for
power supply of a GPS receiver, data transfer
or other own solutions. (Support for TX/RX
signal in the device is required.)
The holder is attached onto a tilt swivel so it
can be adjusted in order to avoid light reflec-
tion. Attach onto the ProClip Mounting
Platform.
Molex Adapter System
Molex adapter system has overmoulded
connectors and a buit-in resettable fuse (2 A).
The box has protection against peaks and overload.
The product is CE and E approved. Connect the
power cable with a 2 A fuse. 5 Volt out.
2 A charger. 12/24 Volt. Professional installation
recommended.
For a complete range, please visit www.brodit.se
Tel +46 (0)505 109 00
Fax +46 (0)505 445 72
Gesällvägen 8
546 34 Karlsborg, Sweden
www.brodit.se
234492 908
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Brodit Active Holder User manual
-
-
-
Brodit Passive Holder User manual
-
-
-
-
-
-