Data subject to change without notice – 07.01.2020(D)
SPINNER GmbH │ Erzgiessereistr. 33 │ 80335 München │ Germany │ www.spinner-group.com │ info@spinner-group.com
Installation guide for
In-Building panel antennas
1 Introduction and safety advice
This instruction shall provide information how to install the antenna with mounting kits.
All shown tasks are intended to be carried out by qualified personnel only. Safety rules apply
(e.g. for working with heavy loads, radio frequency power signals or tools). In order to prevent
damage to equipment and humans, make sure that no RF power is present at the combiner
during installation.
Please note that satisfactory performance of the system (especially in terms of inter-
modulation) can only be achieved if all jumper cables and connectors are handled properly.
Please make sure that all connectors are clean and free from metal, dust or dirt. Avoid sharp
bends of the connecting jumper cables.
SPINNER does not guarantee for any faults or damage resulting from improper installation.
Data subject to change without notice – 07.01.2020(D)
SPINNER GmbH │ Erzgiessereistr. 33 │ 80335 München │ Germany │ www.spinner-group.com │ info@spinner-group.com
2 Installation
2.1 Install the antenna
Method: Install the antenna on the wall with screws.
Drill the holes (Ø6) in the wall and put the plastic expansion nail into the wall, lock the
mounting plate with these screws (M4*25mm) on the wall. Then buckle the antenna back
plate onto the wall with mounting plate. (See below)
The method is applicable for antenna A77136, A77136C0001, A77136C0002, A77138,
A77139, A77140, A77149 and A77149C0001.
Mounting Plate:
For A77136, A77136C0001, A77136C0002,
A77138, A77139, A77149 and A77149C0001 For A77140
44±0,35
70±0,25
56,5±0,15
6,5±0,3
5,5±0,3
35±0,35
50±0,25
5,5±0,3
1,2±0,15
3,5±0,2
R6
3x Ø5±0,5
77±2
90±0,15
110±2
1,2±0,15
2±0,5
58±0,15
45±0,45
20±0,45
R8
5,5±0,3
4x Ø5±0,5
Data subject to change without notice – 07.01.2020(D)
SPINNER GmbH │ Erzgiessereistr. 33 │ 80335 München │ Germany │ www.spinner-group.com │ info@spinner-group.com
2.2 Warning:
As shown below, the cable of antenna can’t be bent 180°and bending diameter can’t be <
40mm.
3 Operation
After carrying out all described steps, the antenna is ready for use. Make sure that the
specified environmental conditions for operation are not exceeded.
Wrong bending method
Correct bending method
Ø ≥ 40mm
-
1
-
2
-
3
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
TFA Wireless Thermometer PRISMA User manual
-
MICRO-EPSILON CTRatio Owner's manual
-
Nibe PCM S42 Installer Manual
-
GEM 1434 mPos Installation, Operating And Maintenance Instructions
-
CAB MAESTRO 6 Operating instructions
-
CAB MAESTRO 4S Operating instructions
-
Cebora PLASMA PROF 163 ACC User manual
-
Beckhoff AG2210-LP155 MF 1 Operating instructions
-
Ecosoft FK Series User manual
-
