Smart Spa CBMB Installation guide

Hello! I've reviewed the provided user manual for the Spa Bracket installation. This document details how to properly install the brackets under your spa using screws, nuts and mounting blocks. I'm ready to answer any questions you have about the installation process or the components involved.
How many screws are included?

How many self-locking nuts are included?

How many mounting blocks are included?

Which way should the pre-drilled holes face on the corner pieces?

Cover Butler

Under Spa Bracket Installation

You should have the following parts to attach the “Mounting Blocks” to the under spa brackets

versus the spa skirt. 8 Screws, 8 Self Locking Nuts, 2 Mounting Block, and 2 Plates (Figure A).

1. Insert the screws from the bottom up through the plate and then through the corners of the

mounting plate. Attach a locking nut on all 4 screws.

2. Slide the brackets under the spa on the backside of the spa.

Figure A

Bracket

Self Locking

Nuts

Screws

Mounting Block

3. Slide the LONG SIDE of each of the two bottom Corner Pieces into the Mounting Blocks.

Remember, EACH CORNER PIECE MUST HAVE THE PRE-DRILLED HOLES FACING

UP.

From here, refer to the installation manual that you received with the lifter starting at #3.