Page is loading ...
42” Dreambowl or Zen Firebowl setup instructions:
Burner
The firebowl utilizes a CSA approved outdoor burner unit and a custom steel pan that holds the
burner.
For information pertaining
to the safe operation of the burner, maintenance and warranty please refer to the
“Kingsman Outdoor Fire Pit Manual” (included). Specific sections in the manual will also be
referred to in these instructions.
Gas Line
When you ordered the firebowl, you specified either a bottom or side gas line hole. For a bottom
feed, the gas or propane supply must be concealed below the bowl so that the bowl can sit flatly
on a surface. For side gas line, the bowl may be
placed on any flat, secure surface.
For Natural Gas:
NOTE: Installation must be completed by a licensed gas-fitter and comply with local
codes.
Lift stainless steel ring taking care not to contact edge of bowl; then remove burner.
Feed a flexible gas supply line in through the hole in the bottom of the bowl and connect to 3/8” fl
are as per Kingsman Firepit Manual pg 6.
Feed Excess hose into the bottom of the bowl. Reposition burner assembly in bowl aligning the
valve with the valve hole.
For Propane:
Connect propane regulator hose to propane tank as per pages 5-6 of the “Outdoor Fire Pit
Manual”
Connecting Key
Attach connecting key valve to hole in bowl with epoxy and/or small screws. If the burner
assembly needs to be rotated to align with the key, gently turn the burner.
Finishing off
Distribute lava rock over entire surface of burner and steel support ensuring that it is completely
covered (approx 2” depth). If you ordered the “fire glass” this topping goes over the lava rock.
For Operating Instructions, refer to pages 14-15 of the “Kingsman Outdoor Fire Pit Manual”
604-278-4939
2200 Vauxhall Place, Richmond BC V6V 1Z9
Assembly Instructions
for
Zen Concrete Firebowl
Caution: Handle with Care
DreamCast
2200 Vauxhall Place, Richmond BC
604-278-4939 info@dreamcastdesign.net
www.dreamcastdesign.net
Items Included:
1) Concrete Firebowl
2) Custom Stainless Steel Pan
3) Burner Assembly Kit
5) Ignition Key
6) Lava Rock
7) River Rock (if ordered)
Assembly Instruction:
1) Place concrete firebowl outside on a flat stable
surface. Location must be at least 16 inches away from
combustible construction on all sides.
Refer to burner manual.
2) Insert stainless steel pan into concrete firebowl.
Ensure it lays flat and stable.
4) Follow instructions included in burner assembly kit to in-
sert burner.
5) Cover all visible area of stainless steel pan, including
burner, with lava rock.
Care and Maintenance:
DreamCast recommends that fire pits are protected from the rain and snow, if you wish to maintain
original finish. Concrete will react to its environment, and naturally weather and acquire a patina with
time.All fire pits are sealed with a densyfing topical sealer that provides some resistance to water
and staining. This does not mean the concrete is water or stain proof.
Water marks and some surface staining can be removed with a gentle green buffing pad available
from any home hardware or kitchen store.
The concrete can also be cleaned with a mild soap and water solution. Never use abrasives or
strong chemicals as they may scratch and/or stain the surface.
Dreamcast recommend that the fire pit should be covered when not in use for extended periods of
time.
Always ensure that your fire pit is draining water properly (i.e. drainage is not obstructed by debris).
Thank you for purchasing a quality concrete product by DreamCast.
Please refer to the assembly instructions below and the operation manual included with your burner
assembly.
DreamCast Design and Production - Quality Concrete Products
2/3
DreamCast Design and Production - Quality Concrete Products
3/3
Limited 1-Year Warranty
All DreamCast products are guaranteed, at the time of delivery (i) to meet the product specification,
(ii) to conform to the description and standards stipulated on the signed quotation. DreamCast
warrants, for 1 year, its products against defects in material and workmanship. Surface, color and
slight size variations are inherent in the line. DreamCast warrants cracks or breaks resulting from a
structural defect in the product. Damage resulting from excessive overloading, impact or abnormal
abrasion is not covered by this warranty. THIS WARRANTY EXPRESSLY EXCLUDES DAMAGE
DUE TO VANDALISM, GROUND MOVEMENT, NEGLECT OR ABUSE. Exposure to salts will also
invalidate this warranty.
In the event of any defective product disclosed to DreamCast, then DreamCast shall, at its option,
either (i) repair the product or (ii) replace any defective product. DreamCast shall not have any liability
for claims beyond 1 year. The liability of DreamCast shall not, under any circumstances whatsoever
exceed the amount of the price paid or payable for the products sold and delivered by DreamCast.
/
