Ditek DTK-HDMI Installation guide
- Category
- Car kits
- Type
- Installation guide
Doc # INT-100182-001
Part No. 191619 Rev1
INSTALL INSTRUCTIONS
DTK-HDMI1, DTK-HDMI2
DITEK Corporation
ONE DITEK CENTER
1720 Starkey Road
Largo, FL 33771
INSTALLATION
Drawn By: B. Aycock 4-25-19
Approved By: R. Mitchell 4-29-19
DITEK Technical Support Available 24/7
1-888-472-6100 www.diteksurgeprotection.com
This Surge Protective Device (SPD) is a high performance device, designed to provide protection for
sensitive electronic loads connected to service panels, fire panels, or where the SPD is directly connected
to the electronic device. Maximum protection will only be achieved if the SPD is properly installed.
Please read and follow these installation instructions carefully.
NOTICE: This SPD should be installed by a licensed contractor in accordance with the Local and National
Electrical Codes and the following instructions.
APPLICATION:
Surge suppression for HDMI components using HDMI cable and connectors.
INSTRUCTIONS:
Caution: Improper installation voids the warranty. This unit must be connected in series with the
equipment to be protected.
1. Turn off the power to the circuit before beginning installation.
2. Using the HDMI supply cable, connect the cable assembly to the “INPUT” side of the DTK unit.
3. Using a 3’ HDMI patch cord, connect the equipment to the “OUTPUT” side of the DTK unit, as shown.
GROUNDING: This device uses the Ground Pin, Pin 17 of the HDMI supply cable, to dissipate the
overvoltage ESD or other power surge events.
MOUNTING:
4. For mounting, use the included mounting bracket to mount this device near the point of protection.
5. After all connections and mounting have been made and no hazards exist, restore power.
DTK-HDMI2
Dual-Inline HDMI Protection
DTK-HDMI2
Dual-Inline HDMI Protection
Surge Protection
DITEK R
Dual-Inline HDMI Protection
MADE IN USA
www.diteksurgeprotection.com
800-753-2345
This product meets or exceeds HDMI 2.0a specifications
DTK-HDMI2
INPUT/CONNECTION FROM
HDMI COMPONENT
OUTPUT TO NEXT HDMI COMPONENT
ALLOW 3’ FT MINIMUM PATCH CORD
-
1
Ditek DTK-HDMI Installation guide
- Category
- Car kits
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ditek DTK-MRJEXTS Installation guide
-
-
-
-
-
-
-
-
-