2. LG
  3. 27ART10AKPL

LG 27ART10AKPL Installation guide

  • Hello! I've analyzed the provided user guide for the LG Monitor ART10 ART10AKPL. This document details the complete disassembly procedure of the monitor, including step-by-step instructions on how to separate the screen, stand, and other components. It contains cautions to prevent damage during the disassembly. I'm ready to answer any questions you might have regarding the document or the disassembly process.
  • What should I avoid when disassembling the screen?
    How far should I keep the disassembled screen from the stand?
    Do I need to use any tools to disassemble cover?
ART10*
www.lg.com
1
4
Disassembly
Position the screen vertically. 2Push the top of the screen lightly in the
direction of the arrow to disassemble
a part of the cover space. 3Use a wedge or pull it with your hand
to completely disassemble the cover.
Position the screen horizontally and
disassemble the cable holder screw. 5Lower the rear lever and push the bottom
of the screen forward, as shown in the figure. 6Lift the screen, separate the top
of the screen, and hold the screen.
7Press the plug lock, push it in the direction of the arrow,
and then disassemble the screen completely. 8Lay the stand on the box packaging, remove the four screws,
and then disassemble the stand bar.
※ Caution
Avoid pushing it hard.
There is a risk of damage.
※ Do not lift the plug or pull it downward
when disassembling the screen.
Keep the disassembled screen
close to the stand at a distance
of 10 cm or less.
M4L10
1X
M4L34
4X
Plug lock
*MFL718019142307REV01*
Kg
90°
Head
washer
ղࢶQU
৮ࢿػ੉޷૑ࠂઁೞৈ
1BUIGJOEFS6OJUF৻ࢶઁ੘
QU"MJHOTUSPLFPVUTJEF
AB C D E F F G
(mm) (kg)
27ART10AKPL 621 1077 ~ 1277 397 361 29.9 17.5 4.8
Power requirement / /
19V 4.0A
4.0 19
1
M4L34
M4L10
Head
washer
AA
1X4X
Installation
A Insert the stand base into the styrofoam groove as shown in the gure.
B Insert the bar into the hole of the stand base along the groove until it reaches the parting line.
C Secure the four screws.
>10 kg A
M4L34
4X
B
C
www.lg.com
User Install Guide
*MFL718845022201rev01*
4
M4L10
1X
B
A
B
A
A B
Power cable
Power plug
Cable holder
3Hold the screen and secure the power plug.
ACheck the position of the power plug on the back cover of the screen.
BSecure it tightly to the back cover side.
2Check the orientation of the power cable and cable holder.
Secure the screen to the stand.
A Insert the stand hook into the back cover groove and tighten
while pushing the lower part, as shown in the gure.
(Push it until you hear a [click] sound.)
B Secure one screw to the cable holder.
5Secure the ring cover of the stand.
AAlign the screen back cover and ring cover [●mark] and install them.
BCheck if it sits tightly as shown in the gure.
/