vitapur VRFK3U User manual

Installation Instructions (continued):

VRO-3U:

1. Insert a Carbon Block Filter into the 1st filter housing

bowl which is the one on the water inlet side (red

tubing) of the RO system and install housing bowl

onto the housing head by screwing in the counter-

clockwise direction. Tighten using the wrench supplied.

2. Insert a Carbon Block filter into second housing bowl

and screw the housing bowl onto the housing head

by rotating in the counter-clockwise direction. Tighten

using the wrench supplied.

NOTE: Make sure the seal marks on the head and bowl

are aligned.

VRO-4U:

1. Insert a Sediment Filter (cloth like appearance) into

the 1st filter housing bowl which is the one on the

water inlet side (red tubing) of the RO system and

install housing bowl onto the housing head by

screwing in the counter-clockwise direction. Tighten

using the wrench supplied.

2. Insert a Carbon Block filter into second housing bowl

and screw the housing bowl onto the housing head

by rotating in the counter-clockwise direction. Tighten

using the wrench supplied.

NOTE: Make sure the seal marks on the head and

bowl are aligned.

CAUTION: When looking at the system from the front,

the sediment filter must be on the left and

the carbon block filter must be on the right.

Figure 10.

Figure 11.

Installing the Filter Cartridges and Filter Housing Assembly (See figure 10 or 11):

CAUTION: You must keep the filters and filter housing

upright during assembly for maximum

performance.