Savant - Rollease Shade Motor and Controller Integration Guide
6 of 7
Copyright © 2020 Savant Systems LLC
009-1861-01 | 200228
3. Create Data Table Entries
Each Rollease shade motor must be added to the Shade Data Table with Blueprint. To access the data table, select Tools > Settings > Shades from the
Blueprint menu bar. To add each entry, do the following:
1. Select the add button
.
2. Using the descriptions in the table below, make the required changes to each entry. Each entry corresponds to a shade motor.
3. Select Done once all shade motors have been added.
Shades Settings
Enabled Identifier Location
Master Bed Shade 1
005
Controller Entity
Label
Entity
Show Advanced Columns
Savant App Zone Map
TrueControl Zone Map
Regenerate AllEnable All
Disable All
+
0
Rollease_Shade_Controller Master Bedroom Single Motor Variable Shade
Done
ExportImport
Cancel
Address [2] Address [3] Address [4] Address [5]Address [1]
?
Select + to add an entry to the data table
Field Description (Standard)
Enabled
When checked, the entry (row) is displayed and can be controlled from the Savant user interface.
When unchecked, the entry is not shown in the UI.
Identifier Used by the Host to identify each shade motor. The identifier is automatically populated and can't be changed.
Controller For Rollease shade system, select the Rollease shade motor controller added in section 2.1 above.
Location
Select a Savant zone from the drop-down, or enter a custom location for the shade motor. Note that if using a custom location, the
Savant App Zone Map and/or TrueControl Zone Map must be used to enable the entry in the desired room(s).
Entity
Select Single Motor Variable Shade from the drop-down for all Rollease shades. This entity type adds a slider to the Savant UI that
controls the shade position and movement.
Label Enter a label that identifies the shade. The text entered is displayed next to the button/slider in the Savant UI shade control screen.
Address [1]
Enter the address of the shade motor. The address of each motor is available in the AUTOMATE App. Follow the steps below to locate
the address of each motor. The steps assume the AUTOMATE app is installed on a mobile device and the shade motors have been
discovered and paired with the Rollease shade motor controller.
1. Open the AUTOMATE app.
2. Select the DEVICES tab.
3. Select the shade motor that corresponds to the entry in the Blueprint data table.
4. Select Edit at the top right corner of the SHADE screen.
5. Copy the address listed for the shade motor (SERIAL ADDRESS field), into the Blueprint data table Address 1 field. All
addressing must be entered as a 3-digit number. For example, 5 would be entered as 005, and 12 would be entered as 012.