Electro-Voice XLCi-BGK-FG Bottom Grid Kit Installation guide

Brand: Electro-Voice

Model: XLCi-BGK-FG Bottom Grid Kit

Type: Installation guide

XLCi-BGK-FG Bottom Grid Kit

Assembly and

Installation Instructions

Step 1

Assemble the sidearms to the enclosure rigging

plates using the bottom grid kit and hardware.

Step 3

Install the spreader bar between sidearms and align with numbered hole, attaching with nuts and shoulder bolts.

Enclosure

Sidearm

Split Washer (x2)

1.625 in

(41.3mm)

Long Bolt (x1)

Split Washer (x1)

Nut (x1)

Torque all bolts

to 70-90 in-lbs.

(84-108 cm-kg)

1.625 in

(41.3mm)

Long Bolt (x2)

Nut (x2)

Spreader Bar

Nut (x1)

Shoulder Bolt (x1)

Hole in Sidearm to be

selected by end user.

Step 2

Torque all bolts to 70-90 in-lbs (84-108 cm-kg).

MAKE SURE ALL LINKING HARDWARE IS TIGHTENED TO 70-90 IN-LBS AND THE SHOULDER

BOLTS ARE TIGHTENED TO THE SPREADER BAR BEFORE LIFTING THE ARRAY.

Bottom Grid Kit for berglass weatherized XLCi install loudspeakers.

XLCi-BGK-FG Bottom Grid Kit

Assembly and

Installation Instructions

Step 4

Pull back grid and array using the pull-back points.

DO NOT PULL BACK GRID USING SIDE HOLES ON SIDEARMS. ONLY PULL BACK GRID FROM THE

SUPPLIED SPREADER BARS.

Pull-Back Point

Germany:

Bosch Sicherheitssysteme GmbH Bosch Security Systems, Inc.

Robert-Bosch-Ring 5 12000 Portland Avenue South

85630 Grasbrunn Burnsville MN 55337

Germany USA

www.electrovoice.com

2015.10 | 01 | F.01U.318.348

Electro-Voice XLCi-BGK-FG Bottom Grid Kit Installation guide

Electro-Voice XLCi-BGK-FG Bottom Grid Kit Installation guide

Electro-Voice XLCi-BGK-FG Bottom Grid Kit Installation guide

Related papers

Other documents