2. Mighty Mule
  3. MMTGB
MMTGB

Mighty Mule MMTGB User manual

  • I've analyzed the installation instructions for the Mighty Mule MMTGB Gate Bracket. This document details how to attach the bracket to a cylindrical gate using the provided hardware. I'm ready to answer any questions you have about the installation process or the bracket itself.
  • What is the first step in installing the MMTGB bracket?
    What size bolt is used to connect the bracket to the gate?
    When should the bolts be fully tightened?
MMTGB Bracket
Installation Instructions
MMTGB
10031653 Rev-A
Using the 3/4” length bolt and a nut, connect the existing gate arm bracket to the MMTGB bracket. Do not tighten completely.
Position the gate arm to slide the MMTGB bracket over the desired section of the gate.
Insert the 2 1/2” bolt through the eyes of the MMTGB bracket, then attach the nut. Do not tighten completely.
Finishing Up: With the gate closed and settled in place, tighten the 2 1/2” bolt and nut then tighten the remaining 3/4” bolt and nut. Test the gate
opener, and adjust as necessary.
INSTALLING THE MMTGB BRACKET TO THE GATE CONTROLLER AND GATE
Follow the steps below to attach the MMTGB bracket to cylindrical gate:
Attach
Gate Arm
©2021 Nortek Security & Control LLC. All rights reserved.
Mighty Mule is a registered trademark of Nortek Security & Control LLC.
Mighty Mule Sales: 800-543-4283 | Mighty Mule Technical Service 800-543-1236
For more information on Mighty Mule’s full line of Automatic Gate Operators, Gate Openers and Access Controls visit
www.mightymule.com
BOX CONTENTS
(2) Tube Gate Brackets (2) 3/8-16 x 1” Hex Bolts (2) 3/8-16 x 2.5” Hex Bolts (4) 3/8-16 Hex Nuts (2) 375 X .079 Washers
/