HOBK HBK-T01 Operating instructions

Brand: HOBK

Model: HBK-T01

Type: Operating instructions

HOBK HBK-T01 is a versatile remote control capable of transmitting a signal to control access systems, lamps, and other 433MHz external receivers. It operates on a frequency of 433.92MHz and has a transmission range of up to 50m in an open area. It requires two 3V CR2016 batteries (included) and features a single button for easy operation. Its compact design measures 57.8mm x 33.3mm x 12.5mm, making it convenient to carry and use.

Remote Control Transmitter

HBK-T01

Introduction

This product id versatile remote control that can be used in many fields, such as access control

system, wireless remote control of the lamps and other 433MHz external receivers.

Note: This remote control can only be compatible with the receivers sold in our store. If you use

other sellers’ receiver, please consult us before using.

Specifications

Operating

Voltage

6VDC (Built-in

batteries)

Operating Current

3ma

2pcs 3V CR2016

batteries

Operating Frequency

433.92MHz

Modulation Type

ASK

Transmit Power

15mW

Antenna Gain

3.6dbi

Number of Buttons

Encoding Type

Fixed code

Emission Distance

max. 50m (Open aera)

Case Color

Black

Wireless Remote Control Chip

EV1527

Case Material

Plastic

Case Material

Silicone

Dimensions

57.8L x 33.3W x 12.5H (mm) / 2-9/32" x 1-5/16" x 31/64"

Programming

The programming method of the transmitter depends on the receiver, please refer to the pairing

method of the receiver.

How to Replace the Battery

To replace the battery, open the back case with a screwdriver, then insert batteries with positive

(+)side up. Replace the batteries with 2pcs 3V CR2016 button batteries. Please dispose of the old

batteries properly.

WARNING

To prevent possible serious injury or death:

● NEVER allow small children near batteries.

● If battery is swallowed, immediately notify doctor.

● To reduce the risk of the fire, explosion or chemical burn:

● Replace ONLY with 3V CR2016 button batteries.

● DO NOT recharge, disassemble, heat above 100℃ or incinerate.

FCC Caution：

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

HOBK HBK-T01 Operating instructions

HOBK HBK-T01 Operating instructions

HOBK HBK-T01 Operating instructions

Other documents