2. Ortech
  3. OL-ST8-3CCT+W

Ortech OL-ST8-3CCT+W, OL-ST4-3CCT+W User manual

  • I have reviewed the Instruction Manual for the Line Voltage Microwave Bi-Level Sensor, model SENSOR-MLTS. The document includes detailed, step-by-step installation instructions and diagrams. It emphasizes the need for a qualified electrician to perform the installation and provides essential safety instructions for dealing with high voltage. I'm ready to help with any questions you may have about the sensor described in the manual.
  • What should I do before starting the installation?
    Who should perform the installation?
    What is the first step in the installation process?
1. Disconnect and lock-out all power sources during installation as severe injury or death can result
from electrical shock due to contact with high voltage conductors
3. Ensure all installations are in compliance with applicable electrical codes and that the installation is
completed by qualified installers familiar with the standards and proper safety procedures for high
voltage installation
Instruction Manual
INSTALLATION GUIDE
Line Voltage Microwave Bi-Level Sensor
MODEL SENSOR-MLTS
1. 2. 4.
5.
6.
8. 9.
7.
3.
1. Take out sensor and sensor bracket.
2. Install the sensor and fix it with M4*6
screws.
3. Install the sensor head and fix it with
M3*4 screws.
4. Press the buckle on both sides and
remove the lamp housing.
5. Take off linear strip cover.
6. Install the sensor bracket and fix it with
M3*6 screws.
7. The locking effect is as shown in the fig.
7. Wiring according to the wiring diagram
and checking the wiring is correct.
8. After checking, put back the lamp
housing.
9. The installed effect is shown in fig. 9.
9. The installed effect is shown in fig. 9.
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.ca
205 Summerlea Rd
Brampton, ON L6T 4E5
/