43
NOTE :
Make sure all packing material is removed. If the shipping tape has left a
residue on the door, touch the residue lightly with the adhesive side of
tape of with isopropyl alcohol (most rubbing alcohol is this type).
Do not use a solvent, such as lighter or cleaning fluid, nor an
abrasive cleanser.
HOW TO INSTALL
HOW TO CLEAN
Install refrigerator in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the refrigerator and side wall so the door will open
for a fully usable interior. Refrigerator is not designed for recessed installation.
Level refrigerator so it rests solidly on the floor, without rocking. There are two
leveling glides, one at each front corner. Turn to the left to raise a corner, to
the right to lower it. Use shims under rear corners, if necessary.
If you want, the refrigerator door to close when not held open, adjust glides
so that the front of the refrigerator is raised. However, front corners must
be level with each other, and rear corners with each other.
If you want the refrigerator door to remain motionless when open, adjust
the leveling glides so that all four corners are level with each other.
BEFORE CLEANNING THE REFRIGERATOR FOR YOUR SAFETY, PLEASE
DISCONNECT THE POWER PLUG FROM THE POWER SOURCES.
Cleaners: The cleaners noted below are available. Never use harsh, abrasive
cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, suday cloth, rinse and dry. For stubborn stains
and for periodic waxing, use sillicon wax.
Refrigeration Section:
Wash shelves, drawers and other removable parts in warm
sudsy water, rinse and dry. Wash interior with baking soda solution (3 table
spoons to one quart of water) or warm sudsy water.
Magnetic Door Seals: Wash with warm sudsy water.
The finishing touch: Replace all parts, and return TEMPERATURE
CONTROL to desired temperature.
Leveling
Location
WARNING
METHODS OF SAFE INSTALLATION
1. SAFE INSTALLATION PLACE FOR YOUR REFRIGERATOR
•
Place the refrigerator
on hard and level
floor.
• Place your refrigerator
where there is no heat
source nearby.
High surrounding
temperature will lower
cooling efficiency and
increases your electricity
bill.
• Place the refrigerator in
an area with low
moisture.
Splashing water or a
high moisture area may
cause a short circuit
and make rusting
easier.
•
Avoid places that are
exposed to smoke.
The discoloring can
occur to the
refrigerator.
• For good ventilation
place refrigerator with
the spaced specified on
the figure.
This helps cooling
efficiency and lowers the
electricity bill.