2. SENSIRION
  3. EK-P4

SENSIRION EK-P4 Operating instructions

  • Hello! I've reviewed the Quick Start Guide for the Sensirion SDP3x SF06 Chip Flow Meter. This document details how to connect the device to your PC, install the required drivers, and configure the measurement settings using the USB RS485 Sensor Viewer. I can help you with specific steps like selecting the correct COM port, adjusting the scale factor, or setting the correct command HEX. Feel free to ask any questions about the process.
  • What driver do I need for the sensor cable?
    Where can I download the software?
    Which sensor product should I select?
Quick Start Guide
EK-P4
Quick Start Guide EK-P4
1Install FTDI USB driver for the sensor cable.
(http://www.ftdichip.com/Drivers/VCP.htm)
3Connect the USB sensor cable to the sensor PCB and the PC.
4Start up the USB RS485 Sensor Viewer.
5Under COM Hardware, select «RS485/USB Sensor cable».
6Select the sensor product «Sensirion Flow Meters (SF06 Chip)».
2Install software after download from: www.sensirion.com/USB-viewer
7Select COM port and press «OK». Highest COM port is most often correct.
9Press «Run».
8The SF06 Viewer appears. Adjust the following settings first:
§ Change units to «Pascal».
§ Set scale factor to 60.
§ Set sampling time to 1ms or more.
§ Enter command HEX 0x3603.
160600-EK-P4
SENSIRION AG
Laubisruetistrasse 50
8712 Staefa
Switzerland
Phone + 41 44 306 40 00
Fax + 41 44 306 40 30
[email protected]
www.sensirion.com
For more information about Sensirion's differential pressure
sensors of the SDP3x series, please visit www.sensirion.com/sdp3x or
contact our technical customer support team:
/