2. SPYKER
  3. KSP11-FD3

SPYKER KSP11-FD3 Owner's manual

  • I have reviewed the Installation Instructions for the KSP11-FD3 spreader. This document guides you through the process of attaching the deflector, starting with removing locknuts and ending with securing the deflector. I'm ready to answer any questions about the instructions or the device itself.
  • How many 1/4" locknuts need to be removed?
    What is used to secure the Deflector?
    What is installed before the Deflector?
1008340 Rev. A
KSP11-FD3
1. Remove (4) 1/4" Locknuts that hold the Hopper
Braces to the Frame.
Installation Instructions
1008340 Rev. A
2. Install left and right Deflector Brackets onto Bolts
and re-install 1/4" Locknuts removed in Step 1.
NOTE Orientation as shown in illustration.
3. Slide Full Deflector onto Brackets and secure using
(2) 1/4" x 3/4" Carriage Bolts and T-Knobs.
/