SmartStraps 159, 262 Owner's manual

  • Hello, I've reviewed the user manual for the Ratchet Tie Down. This document provides instructions on how to thread and release the tie down, ensuring secure cargo transport. I am ready to answer you questions on the manual or device itself.
  • How far should the Ratchet Handle be opened when threading?
    How far should the Ratchet Handle be opened when releasing?
    What should I do after pumping the ratchet when threading?
How to Thread or Release
A Ratchet Tie Down
Threading a Ratchet
Open Ratchet Handle approximately 100°
Split Axel should be oriented as shown to allow webbing to be fed
through
Feed webbing through the ratchet axel (from the backside of the
ratchet)
Feed webbing over the top of the axel
Fasten hooks to the tie down points on your truck or trailer
Pull webbing taut
Pump ratchet until cargo is secure
Tie off access webbing and check to make sure cargo is secure
Releasing a Ratchet
Squeeze release pawl and open the ratchet handle until it is
approximately 180°
Tug the ratchet strap out of the ratchet. Depending on the load you
had tied down, you may need to unthread the strap from the ratchet
mechanism entirely, or you might be able to just loosen the strap
enough to slide it out of the way and remove the load.
/