Nesco ES-08 User manual

“NESCO

®”

is a registered trademark of The Metal Ware Corporaon.

The Metal Ware Corporaon

1700 Monroe St., P.O. Box 237

Two Rivers, WI 54241-0237

Phone: 1-800-288-4545

Table of Contents

Important Safeguards .............................................................................1

Parts, Assembly and Operaon ...............................................................2

Care and Cleaning and Cooking Tips ......................................................3

One Year Limited Warranty .....................................................................4

Table des Maères

Garanes importantes ........................................................................... 5

Pièces, le montage et le fonconnement ...............................................6

Neoyage et entreen et Conseils de cuisine ........................................ 7

Garane restreinte d’un an ..................................................................... 8

Índice

Salvaguardas importantes ...................................................................... 9

Las piezas, montaje y funcionamiento ..................................................10

Cuidado y limpieza y consejos de cocina ..............................................11

Garana limitada de un año .................................................................12

For accessories and additional products, go to

www

.nesco.com

Rated 800 Was 120 Volts, 60 Hz

English

- This product is designed for household use only -

When using electrical appliances, basic safety precauons should always be

followed, including the following:

IMPORTANT SAFEGUARDS!

1. READ AND SAVE ALL INSTRUCTIONS.

2. Do not touch hot surfaces. Use handles or knobs.

3. To protect against electric shock do not immerse cord, plug, or temperature

controller in water or other liquid.

4. Close supervision is necessary when any appliance is used by or near

children.

5. Unplug from electrical outlet when not in use and before cleaning. Allow to

cool before pung on or taking o parts, and before cleaning.

6. Do not operate any appliance with a damaged cord or plug or aer the

appliance malfuncons or has been damaged in any manner. To avoid hazards,

return appliance to NESCO

Factory Service Department for examinaon, repair

or adjustment.

7. The use of accessory aachments not recommended by the manufacturer may

result in re, electric shock or injury to persons.

8. Do not use outdoors.

9. Do not let cord hang over edge of table or counter, or touch hot surfaces.

10. Do not place on or near a hot gas or electrical burner or in a heated oven.

11. Extreme CAUTION must be used when moving an appliance containing hot oil

or or other hot liquids.

12. Always aach plug to appliance rst, then plug cord in the wall outlet. To

disconnect, turn any control to OFF, then remove plug from wall outlet.

13. Do not use appliance for other than intended use.

14. Always place appliance on a at and stable surface.

15. While in use, keep appliance out of the reach of babies and children.

16. Do not leave appliance unaended while in use.

SAVE THESE INSTRUCTIONS!

Polarized Plug: This appliance has a polarized plug (one blade is wider than the

other). To reduce risk of electric shock, plug is intended to t into polarized outlet

only one way. If the plug does not t fully into the outlet, reverse the plug. If it sll

does not t, contact a qualied electrician. Do not try to modify the plug in any way.

Short Cord Instrucons: A short power supply cord is provided to reduce the risk

resulng from becoming entangled in or tripping over a longer cord. Extension cords

may be used if care is exercised in their use. If an extension cord is used, the marked

electrical rang of the cord should be at least as great as the electrical rang of the

appliance. The longer cord should be arranged so that it will not drape over the

tabletop where it can be pulled on by children or tripped over unintenonally.

English

Parts

How to assemble your electric skillet

Remove all parts from the packaging.

1. Locate and remove Lid Knob in packaging.

2. Place the screw through center hole of lid. The head of screw to inside of lid.

3. Place Protector Ring over screw threads on the outside of lid. Rough side of ring

facing glass.

4. Turn Lid Knob onto screw thread while pressing on head of screw.

5. Tighten screw unl snug. Do not overghten. The Lid is now ready for use.

Before rst use

Before using the appliance, READ AND SAVE ALL INSTRUCTIONS. Wipe down the

appliance with a so damp cloth and make sure there is no metal or foreign objects

on the temperature control. Wipe dry with so cloth.

Operaon

1. Place appliance on a at, heat resistant, stable surface in a well venlated area.

2. Make sure the temperature controller is in OFF posion. Insert control into inlet

on the side of skillet. Then insert plug into electrical outlet.

3. Adjust controller to desired seng. NOTE: The signal light on controller

indicates heat seng. When desired seng is reached, the light will turn o.

It will connue to cycle on and o during use to indicate heat seng is being

automacally maintained.

4. Preheat the skillet with the lid on for 10 minutes or unl the indicator light goes out.

NOTE: The cooking temperatures listed in this user manual are esmates. Adjust the

cooking temperature slightly up or down to achieve the results you prefer.

5. A steam vent is located on the Glass Lid. The steam vent allows steam to escape

while cooking with the lid in place. CAUTION: Escaping steam is hot! Be careful

when removing or liing lid. Oven mis are recommended when removing cover

from skillet base or when replacing it.

Handles Lid Knob

Temperature

Controller

Cooking Plate

Glass Lid

English

Operaon (connued)

6. Place food directly onto cooking surface and cook to desired doneness.

7. When nished cooking, turn controller to OFF and remove plug from power

outlet.IMPORTANT: To avoid injury wait unl the appliance has cooled before

removing the temperature controller.

NOTE: If heang oil, always leave the lid o. If oil smokes, immediately turn skillet

“OFF” and allow to cool.

Care and Cleaning Instrucons

1. Turn temperature controller to OFF and unplug cord from power outlet.

2. Always allow grill to cool completely before cleaning and removing temperature

controller.

3. Remove the temperature controller from unit and wipe clean with a dry towel.

NEVER IMMERSE TEMPERATURE CONTROLLER IN WATER OR ANY OTHER

LIQUID.

4. Allow base to cool completely before cleaning. Absorb any excess water or grease

from base with a paper towel.

5. Immerse the skillet and lid in warm, soapy water and wash with a so cloth. Rinse

well and dry. All parts, except the temperature controller, are fully immersible and

dishwasher safe.

6. NOTE: Do Not use steel wool, abrasive cleaners, or metal scouring pads on

cooking surfaces as this will damage the non-sck coang.

Cooking Tips

• Before using the skillet for the rst me, lightly brush cooking surface with

vegetable oil. Heat, uncovered, to 300°F. Turn“OFF” and cool completely. Wipe

away excess oil.

• Metal utensils may scratch the non-sck surface.

• This skillet is not designed to deep fry. To pan-fry, do not use more than 1 cup of

oil. Select a vegetable oil or peanut oil for frying. Buer and olive oil should only

be used to sauté foods on a lower temperature seng.

English

ONE YEAR LIMITED WARRANTY

This appliance is warranted for one year from date of original purchase against

defects in material and workmanship. This warranty does not cover transportaon

damage, misuse, accident or similar incident. This warranty gives you specic legal

rights and you may have other rights, which vary from state to state. This product

is intended for household use only, not for commercial use. Warranty does not

cover commercial use.

Your new NESCO

appliance comes equipped with numerous safety features.

Any aempt to interfere with the operaon of these safety features makes this

warranty null and void. In the event we receive an appliance for service that has

been tampered with, we reserve the right to restore it to its original state and

charge for the repair.

For service in warranty - Defecve products may be returned, postage prepaid,

with a descripon of the defect to: The Metal Ware Corporaon, 1700 Monroe

Street, Two Rivers, Wisconsin 54241, for no-charge repair or replacement at our

opon.

Must include proof of purchase or copy of original bill of sale when returning

product for warranty service.

Please call Customer Sasfacon at 1-800-288-4545 to obtain a Return

Authorizaon before shipping.

• For service in warranty, follow instrucons set forth in warranty. When ordering

new parts, make sure that you always menon the model number of the

product.

• Call us on our toll free number, 1-800-288-4545 and tell us about your problem.

• If we instruct you to send all or part of your appliance to us for repair or

replacement, our Customer Sasfacon representave will provide a Return

Authorizaon number (this number noes our receiving department to

expedite your repair). Pack your unit carefully in a sturdy carton with sucient

padding to prevent damage because any damage caused in shipping is not

covered by the warranty.

• Print your name, address and Return Authorizaon number on the carton.

• Write a leer explaining the problem. Include the following: your name, address

and telephone number and a copy of the original bill of sale.

• Aach the sealed envelope containing the leer inside the carton. Insure the

package for the value of the NESCO

appliance and ship prepaid to:

An: Factory Service Dept.

The Metal Ware Corporaon

1700 Monroe Street

Two Rivers, WI 54241

1 - 800 - 288 - 4545

Nesco ES-08 User manual

Related papers

Other documents