INSTALL INSTRUCTIONS C-TTB-CV
HALF SIZE TRUNK TRAY
1995-2008 FORD CROWN VICTORIA
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, #10, #8
Screwdriver set
Wrench – 7/16”
HARDWARE:
ITEM# QTY DESCRIPTION PART #
1 1 Passenger side front foot S-1-000958
2 1 Driver side front foot S-1-000959
3 1 Support plate S-1-000964
4 1 Driver side rear foot S-1-TA001HBS1-006A
5 1 Passenger side rear foot S-1-TA001HBS1-006B
11 ¼” Flat washer GSM31005
11 ¼” Serrated nut GSM30023
5 ¼” x ¾” Hex head bolt GSM33001
4 8-32 Keps nut GSM30027
Always!
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
1
2
3
5
4
(Attaches w/ 8-32 keps nuts)
(Attaches w/ ¼” serrated nuts)
(Attaches w/ ¼” serrated nuts)
(Attaches w/ 8-32 keps nuts)
(Bolts to back seat wall)
C-TTB-CV_INST_9-07
INSTALL INSTRUCTIONS: (refer to drawing on previous page)
1. Remove spare tire and jack from trunk.
2. Slide tray into the top shelf of the trunk.
3. Loosely attach (items #1 & 2) front mounting feet to the tray, using ¼” x ¾” Hex
head bolts, washers, and nylock nuts.
4. Loosely attach front mounting feet to the vehicle, using ¼” x 1” Hex head bolts,
washers, and nylock nuts.
5. Loosely attach (items #4 & 5) driver/passenger side rear mounting feet to the tray,
using ¼” x ¾” Hex head bolts, washers, and nylock nuts.
6. Loosely attach (items #4 & 5) driver/passenger side rear mounting feet to the vehicle,
using ¼” x 1” Hex head bolts, washers, and nylock nuts.
7. Check to see if tray opens and closes smoothly.
8. Tighten all hardware.
/
