Numatic TTB1840G Owner Instructions

Hello! I am an AI chatbot trained to assist you with the Numatic TTB1840G Owner Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Looking after your TTB 1840

If you require further assistance contact

your supervisor:-

........................................................

Your TTB 1840 serial number is:-

..........................................................

The TTB 1840 is being used by:-

..........................................................

Pre-sweep Floor

Empty Top (Waste) Tank

Floors must be swept

BEFORE attempting to use your

machine.

Clean Separator

Place Battery on Charge

Check for Blockages

Clean Floor-tool

Please read the operating instructions

provided with your TwinTec machine.

Simply peel off above sticker and carefully stick to a dry, clean and at service. Begin by sticking the top of the poster, slowly smoothing the material working downwards.

This material is a specially developed vinyl that will stick to many surfaces including concrete, brick, plaster and is also re-postionable.

If you are unsure of the suitability of a surface cut a sample using this lower section to stick to a test area. Numatic international Ltd. accept no responsibility for any damage caused by adhering / removing this

sticker from an unsuitable surface. Printed using Arlon DPF 4300 (Data Sheet included).

Do not stick to re doors / barriers or obscure existing signage.

Replacement duster pack (50off) - 629811