NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
INSTALLATION INSTRUCTIONS FOR LENNOX STAINLESS STEEL OUTDOOR WEATHER
COVERS 36-EODC (P/N H4647) & 42-EODC (P/N H4648)
OUTDOOR WEATHER COVER
HEARTH PRODUCTS
KITS AND ACCESSORIES
750,211M
04/2006
Printed in U.S.A. © 2006 by LHP
P/N 750,211M REV. N/C 04/2006
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
LHP
1110 West Taft Avenue
Orange, CA 92865
GENERAL INFORMATION
The Stainless Steel Outdoor Weather Cover, is an available accessory to provide protection for the interior of your Lennox outdoor fireplace.
The cover is not designed to fit over the optional doors.
INSTALLATION INSTRUCTIONS
To install the weather cover, refer to
Figure 1
and follow the steps outlined below:
Step 1. Insert the upper flange of the cover into the face top opening.
Step 2. Push the bottom towards the fireplace, while holding the cover up at the same time.
Step 3. Hook the bottom of the weather cover inside the face opening as shown in
Figure 1
.
Figure 1
Insert Upper Flange
Into The Face Top
Opening
Push The Bottom
Towards The Fireplace,
While Holding The Cover
Up At The Same Time.
Support Frame