the other end to your device. The device
will start charging automatically.
3. It takes 3 hours to fully charge your battery
with a traveler charger for the first time. On
a deskstand, Unplug the device from the
charger when charging is complete, and
you may now use the device.
4. When the LED light is in red, it means the
battery is charging.
5. When the LED light is in green, it means
the charging is complete.
6. The battery icon on task bar on Today
screen shows the battery status. You may
also check the battery status in Start >
Settings > System Tab > Battery Tab
Install and Remove SIM Card
1. Before inserting/ removing a SIM card,
please make sure that the device is turned
off and is not connected to any power
supply by the USB cable or charger.
2. Remove the battery from the battery slot.
3. Insert/ Remove the SIM card from the SIM
card slot.
4. Replace the battery back to the battery slot.
Power On
Press Power On/ off key on the top of the
device to turn on the device
Power Off
Press and hold Power On/ Off key on the top of
the device for about 5 seconds while the power
is on.
GIGA-BYTE COMMUNICATIONS INC.
8F,No. 43, Fu-Hsin Road, Hsin-Tien, Taipei
County, Taiwan
+886-2- 82192136
www.gigabytecm.com
support@gigabytecm.com
4
MW998