Hans Grohe AXOR Starck 10111009 Instructions For Use/Assembly Instructions

Type
Instructions For Use/Assembly Instructions

Hans Grohe AXOR Starck 10111009 is a single-lever mixer for basin mounting with pop-up waste set. It features EcoSmart technology that reduces water consumption by up to 60% without compromising performance. The mixer is equipped with a flow limiter that can be removed to increase water flow if necessary. The mixer is made of high-quality materials and has a durable finish. It is easy to install and maintain, making it a great choice for any bathroom.

Hans Grohe AXOR Starck 10111009 is a single-lever mixer for basin mounting with pop-up waste set. It features EcoSmart technology that reduces water consumption by up to 60% without compromising performance. The mixer is equipped with a flow limiter that can be removed to increase water flow if necessary. The mixer is made of high-quality materials and has a durable finish. It is easy to install and maintain, making it a great choice for any bathroom.

Starck
10120009
DE Gebrauchsanleitung / Montageanleitung 2
EN Instructions for use / assembly instructions 3
Starck
101110 0 9
Montage siehe Seite 4
Installationskitt nicht im Lieferumfang
enthalten
Montageschlüssel (58085000) nicht im
Lieferumfang enthalten
Sonderzubehör
Serviceteile (siehe Seite 8)
Reinigung
siehe beiliegende Broschüre.
Bedienung (siehe Seite 6)
Hansgrohe empfiehlt, morgens oder nach
längeren Stagnationszeiten den ersten
halben Liter nicht als Trinkwasser zu
verwenden.
Durchflussdiagramm
(siehe Seite 7)
mit EcoSmart
®
ohne EcoSmart
®
Maße (siehe Seite 7)
Kein essigsäurehaltiges Silikon verwenden!
Symbolerklärung
6 Sicherheitshinweise
6 Bei der Montage müssen zur Vermeidung von
Quetsch- und Schnittverletzungen Handschuhe
getragen werden.
6 Das Produkt darf nur zu Bade-, Hygiene- und
Körperreinigungszwecken eingesetzt werden.
6 Große Druckunterschiede zwischen den Kalt- und
Warmwasseranschlüssen müssen ausgeglichen
werden.
Montagehinweise
Die Armatur muss nach den gültigen Normen montiert,
gespült und geprüft werden.
Vor der Montage muss das Produkt auf
Transportschäden untersucht werden.
Nach dem Einbau werden keine Transport- oder
Oberflächenschäden anerkannt.
Bei Problemen mit dem Durchlauferhitzer oder wenn
mehr Wasserdurchsatz gewünscht wird, kann der
EcoSmart
®
(Durchflussbegrenzer), der hinter dem
Luftsprudler sitzt, entfernt werden.
Technische Daten
Armatur serienmäßig mit EcoSmart
®
(Durchflussbegrenzer)
Betriebsdruck: max. 1 MPa
Empfohlener Betriebsdruck: 0,1 – 0,5 MPa
Prüfdruck: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Heißwassertemperatur: max. 80°C
Empfohlene Heißwassertemperatur: 65°C
Thermische Desinfektion: max. 70°C / 4 min
Hansgrohe Armaturen können in Verbindung mit
hydraulisch und thermisch gesteuerten Durchlauferhitzern
eingesetzt werden, wenn der Fließdruck mindestens
0,15 MPa beträgt.
Das Produkt ist ausschließlich für Trinkwasser konzipiert!
Deutsch
2
Assembly see page 4
Installation putty order as an extra
special tool (58085000) order as an extra
Special accessories
Spare parts (see page 8)
Cleaning
see enclosed brochure.
Operation (see page 6)
Hansgrohe recommends not to use as
drinking water the first half liter of water
drawn in the morning or after a prolonged
period of non-use.
Flow diagram
(see page 7)
with EcoSmart
®
without EcoSmart
®
Dimensions (see page 7)
Do not use silicone containing acetic acid!
Symbol description
6 Safety Notes
6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The shower system may only be used for bathing,
hygienic and body cleansing purposes.
6 The hot and cold supplies must be of equal
pressures.
Installation Instructions
The fitting must be installed, flushed and tested after
the valid norms.
Prior to installation, inspect the product for transport
damages.
After it has been installed, no transport or surface
damage will be honoured.
If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
®
(flow limiter) located behind the aerator can be
removed.
Technical Data
This mixer series-produced with EcoSmart
®
(flow
limiter)
Operating pressure: max. 1 MPa
Recommended operating pressure: 0,1 – 0,5 MPa
Test pressure: 1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature: max. 80°C
Recommended hot water temp.: 65°C
Thermal disinfection: max. 70°C / 4 min
Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
The product is exclusively designed for drinking water!
English
3
4
1
4
2
3
6
1.
2.
SW 10 mm
SW 24 mm
5
1.
2.
3.
4.
10 Nm
7 Nm
5
11
11
58085000
10
11 12
9
7
58085000
8
9
50 Ncm
6
13 15
14
> 2 min
schließen / closeöffnen /open
warm / hot kalt / cold
7
Starck
10111009 / 10120009
Starck
10111009
Starck
10120009
94139000
94139007
8
EcoSmart
®
Starck
10111009 / 10120009
Hansgrohe · Auestraße 5 - 9 · D-77761 Schiltach · Telefon +49 (0) 78 36/51-1282 · Telefax +49 (0) 7836/511440
E-Mail: [email protected] · Internet: www.hansgrohe.com
09/2012
9.05025.62
97158000
97155000
10092000
96339000
95379000
97157000
97774000
97443000
(450 mm)
97489000
(900 mm)
98186000
(30x2)
97767000
95289000
98147000
(26x2)
98155000
(34x4)
96324000
94139000
94139007
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Hans Grohe AXOR Starck 10111009 Instructions For Use/Assembly Instructions

Type
Instructions For Use/Assembly Instructions

Hans Grohe AXOR Starck 10111009 is a single-lever mixer for basin mounting with pop-up waste set. It features EcoSmart technology that reduces water consumption by up to 60% without compromising performance. The mixer is equipped with a flow limiter that can be removed to increase water flow if necessary. The mixer is made of high-quality materials and has a durable finish. It is easy to install and maintain, making it a great choice for any bathroom.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages