10
Remove the cover (part. 13) and the piston (part. 10), then remove the stem (part. 4)
Replace the broken-down part making (part. 3, 11 and 12) sure you are using the correct
spare parts.
6.2) Reassembling
When it is assembled again, cleaning is essential for assuring a long service life.
Art. 2944 (Spring Return Actuator – Normal Closed):
Put the Stem (part. 4) inside of body actuator (part. 1). Put the springs (part. 7 and 8) in the
inside part and put the piston (part. 10), using some sort of lubricant to help perform the task.
Put the cover (part. 13) and then with the help of a small press apply some pressure on the
cover for compress the springs (part. 7 and 8) and then be able to put the seeger ring (part
14). Slowly loosen the pressure between these two planes until you can make sure the
seeger is properly placed.
Art. 2949 (Double Acting Actuator):
Put the Stem (part. 4) inside of body actuator (part. 1), then put the piston (part. 10), using
some sort of lubricant to help perform the task.
Put the cover (part. 13) and then with the help of a small press apply some pressure on the
cover and then be able to put the seeger ring (part 14). Slowly loosen the pressure between
these two planes until you can make sure the seeger is properly placed.
7) Hygiene and Safety Instructions:
When operating any kind of element, you must follow the security instructions and it is
recommended to use personal protection gadgets:
1) Protect your eyes.
2) Wear gloves and appropriate working clothes.
3) Wear safety footwear.
4) Wear a helmet.
5) Have running water at hand.