Page is loading ...
(E) 4/06
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Carefully unpack and identify all parts before
assembly. Bulb not included.
1. Follow enclosed supplement installation instructions
for electrical and fixture installation onto house
outlet box. If you do not have an outlet box at
desired location to attach the fixture than hire a
qualified electrician to create one.
2. Screw the threaded stud into finial. Then insert
other end of the threaded pipe through bottom hole
of glass shade and lock into position with a washer
and hex nut from above. Do not over tighten.
3. Install glass shade by slipping through the crown
until it stops.
4. Install crown onto fixture plate by fastening with two
small cap nuts.
5. Install light bulb (not included). See relamping label
located near socket area for type and maximum
allowed wattage.
Fixture Plate
Glass Shade
ASSEMBLY INSTRUCTIONS FOR WB1288
1
3
2
4
5
Threaded Stud
Finial
Bulb
(not included)
Washer &
Hex Nut
Small Cap Nut
Cap Nut
Crown
/
