Black Wire
to Terminal 9
Black Wire
Black Wire
by Removing the Three Hex Nuts;
1) 11/32" or 9mm Socket & Socket Wrench
Tool Required to Remove Hex Nut:
Lanyard Stop
Feed Lanyard Stop Through Hole First;
then the Four Wires.
Bundle Up Lanyard & Wires
Through Louver.
Size #8 Hex Nut
Armored Cord Handset Retainer:
Re-install Armored Cord Handset:
1
10
USB-B
Black Wire to Terminal 4
Green Wire to Terminal 3
Yellow Wire to Terminal 2
Red Wire to Termianl 1
Terminal
Audio Module (UAAM)
USB to Analog
Hookswitch
Use Provided #00 Screw Driver
to Install Wires to Terminal Block
Block
Armored Cord
Armored Cord
Handset Retainer
Disconnect Before Proceed
to Terminal 5
Red Wire
***
***
Slide Out Lanyard Stop from
To Remove the Armored Cord Handset Retainer
Slide Armored Cord &
Hole
Lanyard Stop into Slot.
To Remove Damaged Armored Cord Handset:
Also Disconnect Wires from UAAM (See Above Diagram).
Out
Pull Cord
Armored Cord
Handset Retainer
Finally, Re-install
the Three Hex Nuts.
1
2
3
2b
2a
3a
3b
3c
3d
/
