Kohler K-10124-BGD Installation guide

Kohler
Brand
Kohler
Model
K-10124-BGD
Category
Sanitary ware
Type
Installation guide
Installation Guide
Shower Arm and Flange
M product numbers are for Mexico (i.e. K-12345M)
Los números de productos seguidos de
M corresponden a México (Ej.
K-12345M)
Français, page“ Français-1”
Español, página“ Español-1”
K-10124
1046641-2-A
Tools and Materials
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems, please don’t
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.
Before You Begin
Observe all local plumbing and building codes.
Shut off the main water supply.
For roughing-in specifications, please refer to the faucet
manufacturer’s installation instructions.
Kohler Co. reserves the right to make revisions in the design of
products without notice, as specified in the Price Book.
Adjustable
Wrench
Strap
Wrench
Thread
Sealant
Plumbers
Putty
Hex
Wrench
1046641-2-A 2 Kohler Co.
1. Install the Shower Arm
NOTE: The showerhead with adapter are not provided.
Remove the temporary nipple from the shower ell.
Apply a bead of plumbers putty or other sealant to the back of
the wall flange according to the manufacturer’s instructions.
Place the wall flange onto the long end of the shower arm just
below the threads, as illustrated.
Apply thread sealant tape to the threads of each end of the
shower arm.
Place the shower arm in the shower ell.
Carefully tighten the shower arm to the shower ell with a clean
strap wrench.
Press the wall flange against the finished wall.
Secure the flange to the shower arm by tightening the setscrew.
Remove any excess putty.
Turn on the water and allow water to flow through the shower
arm to flush the system of any debris.
Turn off the water.
Thread the adapter (not provided) onto the showerhead until
hand-tight.
Hand tighten the showerhead (not provided) to the shower arm.
Apply
plumbers
putty.
Shower Ell
Wall Flange
Shower Arm
Showerhead (Not Provided)
Adapter (Not
Provided)
Setscrew
Kohler Co. 3 1046641-2-A
Install the Shower Arm (cont.)
Use a clean strap wrench to completely tighten the showerhead to
the shower arm.
Check for proper operation.
1046641-2-A 4 Kohler Co.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
USA: 1-800-4-KOHLER
Canada: 1-800-964-5590
México: 001-877-680-1310
kohler.com
©2005 Kohler Co.
1046641-2-A
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

Kohler K-10124-BGD Installation guide

Kohler
Brand
Kohler
Model
K-10124-BGD
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents