• Press the On/Off switch to
activate the laser.
• Adjust the Measuring Tape with
Marking Laser, with the assistance
of the foot screws , such that
the bubbles in the spirit levels
and lie exactly between the
markings. If you screw out the
foot screw a little further, you
can project the laser line somewhat
higher.
• Direct the laser line onto the
desired wall.
• Turn the covering flap all the
way to the left or right, dependant
on whether you wish to project
a vertical or a horizontal line.
- 14 -
KH3229_UK 04.12.2006 13:36 Uhr Seite 14