Mircom LT-1016 BB-700WP Installation guide
- Category
- Mounting kits
- Type
- Installation guide
BB-700WP Installation Instructions
LT-1016 Rev.1
Dec 2011
BB-700WP
GK-022
GK-022
BB-700WP
GK-022BB-700WP
GK-021
Manual Station
Manual Station
GK-021
NOTCHES ARE
ON BOTTOM
GK-021
Manual Station
1. Remove the adhesive backing paper
from the GK-022 neoprene gasket.
2. Align the four screw holes on the
back in the gasket with the matching
holes on the back of the BB-700WP.
3. Press the adhesive side of the GK-
022 rmly into place on the BB-
700WP. The BB-700WP is now
ready for mounting. When mounting
the BB-700WP ensure the arrow on
the inside of the backbox is pointing
upwards.
4. Remove the adhesive backing paper
from the GK-021 neoprene gasket.
5. Align with the four mounting holes
and terminal block on the back of the
manual station.
6. Press the adhesive side of the GK-
021 rmly into place on the manual
station.
7. Ensure that the arrow on the inside
of the BB-700WP is pointing upwards
and unlock the manual station.
8. Align the four mounting holes of the
manual station and the BB-700WP.
9. Firmly press the manual station onto
the BB-700WP and secure with the
screws provided.
GK-022
BB-700WP
GK-021
Manual Station
BB-700WP
Manual Station
-
1
Mircom LT-1016 BB-700WP Installation guide
- Category
- Mounting kits
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI