Mircom LT-899ADD INX-10AC Installation guide

LT-899ADD Aug 2011 Page 1 of 1

INX-10AC

Addressable Booster Chassis

Installation Instructions

Addendum to LT-899 INX-10A Manual

Module Mounting Locations

The INX-10AC is the same as the INX-10A except for how it is installed. The INX-10AC is mounted on a chassis. The

chassis mounts into backboxes BB-5008 or BB-5014 instead of it’s own enclosure. The INX-10AC can be wired into an

addressable loop (SLC) and provides additional power (10A) for signalling circuits (NACs -notification appliance circuits).

The chassis is mounted using twelve #6 HEX nuts onto the backbox studs, see figure below.

INX-10AC Addressable Booster Chassis

Note: Refer to LT-899 INX-10A Installation & Operation Manual for all INX-10AC wiring and set-up information.

All twelve black circles represent mounting studs.

Use #6 HEX nuts provided to secure to backbox

BB-5008 or BB-5014.

All twelve black circles represent mounting studs.

Use #6 HEX nuts provided to secure chassis to

backbox BB-5008 or BB-5014.

INX-10A Board

Battery

Transformer