Allinformation,includingillustrations,isbelievedtobereliable.Users,however,shouldindependentlyevaluatethesuitabilityofeachproductortheirapplication.Innosystemsmakesnowarrantiesastothe

accuracyofcompletenessoftheinformation,anddisclaimsanyliabilityregardingitsuse.Innosystem’sonlyobligationsarethoseinthestandardtermsandconditionsofSaleforthisproduct,andinnocase

willInnosystemsbeliableforanyIncidental,indirectorconsequentialdamagesarisingfromthesale,resale,useormisuseoftheproduct.

Unit17a,LoughbookIndustrialEstate,Bessbrook,Newry,CoDown,BT357EE,UnitedKingdom

t:+44 (0) 28 30 830 006f:+44 (0) 28 30 837 006e:[email protected]w:www.innosystems.co.uk

Inno Adhesion Promoter

AcceleratesthecuringofMegaBondPUandMegaBond

PUSpeed.

InnoAdhesionPromoterisaprimerwithsolvents.Itservesasanadhesive

Colour:transparent/colourless

Density:0.86kg/L(+/-0,04,at20°C(liquidstage)

Propellant:G.P.L.(propane/butane)

Flammability:Extremelyflammable

USER INSTRUCTIONS

-NotsuitableforpurePEandPS.

-Shakecanwellbeforeuse.

-Thesurfacestobecoatedmustbefreeofoil,grease,wax,humidity,dirt,separatingandcaringagents.

-Applyathin,evenlayerapproximately25cmfromthesurfaceoftheplastic.Leavetodry.Anadditionalapplicationis

recommended.