DSPPA mp 1500 Owner's manual

Brand
DSPPA
Model
mp 1500
Category
Musical Equipment
Type
Owner's manual

This manual is also suitable for

1
P.A.SERIES
Public Address Amplifiers MP 1500
MP 2000
MP 2500
MP 3000
MP 3500
MP 4000
Before operating, please read this manual completely!
FEATURES
l Transformer isolated 100V, 70V and 4 Ohms speaker outputs
l 5 LED indicator for status display
l XLR socket and 6.3 mm jack for additional mixer or amplifier link
l Output circuit shorting protection & display
l Series amplifiers of high output power available
OWNER’S MANUAL
Public Address Amplifier
POWER CLIP SIGNAL PROT TEMP
VOLUME
0 10
91
2 8
3 7
64
5
MP2500
PROFESSIONAL AMPLIFIER
2
AMPLIFIER FRONT VIEW
1. AC power switch(1 is power on and the
“power LED” is on )
2. POWER LED indicator
3. CLIP LED indicator (Please reduce
the gain to prevent severely clipped
waveforms reaching the loudspeakers)
4. SIGNAL LED indicator (Output level)
5. PROT LED indicator (DC or
output circuit shorted indicator)
6. TEMP LED indicator
(high temperature indicator)
7. Unit’s fan exhaust window
8. Volume (input attenuator)
AMPLIFIER REAR VIEW and CONNECTIONS
1. fan intake window
2. COM. output
3. 4-16Ω output
4. 70V output
5. 100V output
6. 220V AC fuse
7. XLR input
8. 6.35mm socket input
9. 6.35mm socket link
10. XLR link
11. 220VAC power cord
PROFESSIONAL AMPLIFIER
TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK.DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR
MOISTURE.
DSPPA Acoustic Technology Co.,Ltd.
为了减少火灾或触电的危险,
不要将设备放在能被雨淋或潮湿的地方。
SER.
NO.
COM
INPUT LINK
AUDIO OUTPUTS
4-16Ω 70V
~220 Hz/8A
100V F A
DSPPA
F A
MP2500
F8AL
MP2000
F6AL
MP1500
F10AL
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION!
1 32 4 65
Pre-amp.
MP9811P
Another Amp.
MP series
1110
9
87
or or
Pre-amp.
MP9811P
Another Amp.
MP series
Public Address Amplifier
POWER CLIP SIGNAL PROT TEMP
VOLUME
0 10
91
2 8
3 7
64
5
MP2500
1 2 3456 7 8
PROFESSIONAL AMPLIFIER
3
OPERATING PRECAUTIONS
1. Make sure the AC mains voltage is correct and is the same as that printed on
the rear of the amplifier. Damage caused by connecting the amplifier to
improper AC voltage is not covered by the three-year US warranty.
2. Make sure the power switch is off before making any input or output
connections. It is always a good idea to have the gain controls turned down
during power-up to prevent speaker damage if there is a high signal level at
the inputs.
3. If the PROT Led goes on steadily while power has been turned on and signal
has been fed, there must a trouble of output shorted. Please turn it off and
correct the trouble then turn it on again.
CONNECTING INPUTS
Input connections are made via
either the 3-pin XLR-type connectors
(Figure 1 ) or 6.35mm sockets on the
rear side of the amplifier.
CONNECTING OUTPUTS
Output terminals are on the rear panel. Load can be connected using banana
plugs or spade lugs. A black binding post is considered “COM”, while the three red
binding posts are considered “hot”.
Usually make use of “fixed voltage” (70V or 100V) output, while the each
loudspeaker should use a separate transformer and the total power of connecting
loudspeakers should be less than rated power of amplifier.
Loudspeaker which close to the amplifier also make use of “fixed resistance” (4
Ω) output, while the total resistance of connecting loudspeakers should accord with
4-16Ω.
ground signal
1
2
3
Figure 1 3-pin XLR-type connectors
4
Note:
When connecting loudspeakers, it is better to use one pair of output terminals only.
Never connect the “hot” terminals together.
SPECIFICATIONS:
MODEL
MP1500 MP2000 MP2500 MP3000 MP3500 MP4000
MAX. RATED POWER
350W 450W 650W 1000W 1500W 2000W
Input sensitivity 1.2V
S/N Ratio > 80dB (A weighted) 90dB
Frequency Response
50Hz~15kHz (±3dB)
80Hz-15kHz (±3dB)
THD into 4Ω/1kHz <0.3% <0.5%
Indicators POWER, CLIP, SIGNAL, PROT, and TEMP
Protection Power turn on/turn off,
Overheating, DC voltage & Short Circuit.
Power Requirement AC220~240V / 50~60Hz
Dimensions (W×H×D) 483×88×380mm 483×132×480mm
Net Weight 11kg 12kg 14kg 30kg 35kg 39kg
Gross Weight 12kg 13kg 15kg 33.5kg 38.5kg 42.5kg
Specifications are subject to be changed without notice.
CAUTION
● When the “Power switcher” is off, please pull out the power cord from the socket.
● Please keep the equipment out of water.
● To reduce the risk of electric shock, do not remove the cover.
● No user parts inside. Refer servicing to qualified service personnel.
GUANGZHOU DSPPA AUDIO CO., LTD.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

DSPPA mp 1500 Owner's manual

Brand
DSPPA
Model
mp 1500
Category
Musical Equipment
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents