- 6 -
KH 1156
The scale shows the weight "0".
➩ Place the item(s) to be weighed
into the bowl.
The weight is shown on the display.
If you would like to switch the dis-
play between grammes and ounces,
press the KG/LB-Button .
Adding & Weighing (Tare Function)
You can repeatedly set the scale back
to 0 in order to weigh additional partial
quantities.
➩ To do this, press the Z/T-Button once
. The scale shows 0 Gramm again.
➩ Place the item(s) to be weighed in
the bowl.
In the display, the weight of the newly
placed item(s) is shown.
You can repeat this procedure
several times. However, never place
more than 11 lb on the scale.
Removing Weighed Items
➩ Press the Z/T-Button once .
The scale shows 0 gramme again
➩ Remove the desired amount of
material.
The weight value of the removed
material appears in the display as
a negative value.
You can repeat this procedure
several times.
Setting the Timer
The Timer enables you to set the clock
for a specific period of time, at the end
of which a signal tone sounds. The pre-
set time runs as in a countdown.
➩ Press once on the Clock-Button .
The bell symbol appears in the display
at the top left, next to the clock.
➩ Enter the desired time period with
the Z/T resp. the KG/LB-button .
You can set the time in 10 second steps.
If you hold the Z/T resp. the KG/LB-
button down conti-nuously, the figu-
res run through faster.
➩ Press the Clock-Button , to start the
countdown.
You can stop the timer.
➩ Press once on the Clock-Button ,
to stop the Timer.
You can reset the timer.
➩ Press twice on the Clock-Button ,
to reset the Timer.
When the configured time has elapsed,
a signal tone sounds for 60 seconds.
This signal tone can be switched off by
pressing the On/Off-Button .