Ohlins 08724-10_90_95 Mounting Instruction

Type
Mounting Instruction
This kit should only be installed by an
authorized Öhlins Service Centre!
Öhlins Racing AB cannot be held responsible
for any personal injury or damage that may
occur after installing the Öhlins spring kit.
Contact an Öhlins Service Centre for advice
about how to install and maintain this
product properly.
Öhlins Racing AB, Box 722,
S-194 27 Upplands Väsby, Sweden
Phone +46 8 590 025 00, Fax +46 8 590 025 80,
E-mail: info@ohlins.se, www.ohlins.com
Read more at www.ohlins.com
Replace the standard spring with the Öhlins
spring. Install in the same way as the original
unit.
HOW TO INSTALL
Congratulations!
With this purchase you have made a clear
statement...the high performance Front fork
Spring Kit from Öhlins Racing is nothing but
pure racing breed which means that you have
taken one more step to eliminate luck on your
motorcycle.
The balance between your front fork and
rear suspension will sharpen up and the perfor-
mance of your front fork will improve...30 years
of racing experience is now a crucial part of
your riding experience.
SPRING KIT
FRONT FORK
Part no. 01200-04
Part no. 08724-10/ -90/ -95
HONDA CB600F Hornet and CBR600F
KAWASAKI Z750R
SUZUKI GSX-R600 and R750
Recommendations
Oil: Öhlins Front Fork Fluid 01309-01
Oil Level:
Honda CB600F Hornet 80 mm
Honda CBR600F 80 mm
Kawasaki Z750R 115 mm
Suzuki GSX-R600 110 mm
Suzuki GSX-R750 115 mm
The front fork completely compressed,
without spring and pre-load tube.
  • Page 1 1

Ohlins 08724-10_90_95 Mounting Instruction

Type
Mounting Instruction

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI