ASSEMBLY INSTRUCTIONS
This fixture has been rated for up to 3.8*3-Watt maximum light with LED SMD 2835
The lighting fixture is meant for indoor use.
ASSEMBLY
Please follow the steps (1-5) to install the lighting fixture.
1)
2)
3)
4)
5)
1. To reduce the risk of electric shock, ensure electricity has been turned off at the circuit
breaker or fuse box before beginning.
2. Take the wall bracket off the canopy, Connect your wall bracket to your junction box (not included) using the provided
screws.
3. Make electrical connections using the wire nuts.
4. Being careful that no wiring is left exposed, place the canopy against the mounting surface.
Secure the canopy to the wall bracket with the 2 previously removed ball nuts.
5. Install the shade to the socket.
Thanks for your purchase!
Should you have any questions or concerns, please do not hesitate to contact us by mail address
support@wingbolighting.com
WARNING:
.Check for electric, gas, & plumbing lines before drilling or consult a professional.
.Turn off your electricity at the circuit breaker or main fuse box before installation. Do not restore power to
the line until the light has been fully installed.
-
1
