2. PedSafety
  3. 501-0711
501-0711

PedSafety 501-0711 User guide

  • Hello! I've reviewed the provided Wiring Quick Guide for the PedSafety Guardian Mini. This document details the wiring connections for the SPI within the pedestrian signal head and the AGPS Mini, highlighting 12VDC outputs, and field wiring. I am ready to answer any questions you may have about the installation based on this guide.
  • What is the purpose of the SPI in the Pedestrian Signal Head?
    What type of cable is recommended for the 12VDC connection?
    What is the recommendation for new intersection installations?
Do NOT set the SPI on the bottom of the Pedestrian Signal Head
Cabinet
SPI in the Pedestrian Signal Head (Signal Power Interface)
AGPS Mini wiring connections
(exploded view of terminal block on back)
12 VDC Outputs
WARNING 120 VAC Inputs
Pole
Guardian Mini
Wiring Quick Guide
SPI inside Ped Signal Head
For complete documentation visit http://www.pedsafety.com/product-installation-guides/ ©Campbell Company 2021
Tech Support: (208) 345-7459, option 2
8017
Terminals of the SPI must be connected to the same terminals on the Base Station
Guardian Mini
Field Wires
✓ Utilizes the existing Field Wires from cabinet
to pedestrian push buttons to place calls
✓ NOT polarity dependent
NOTE: For NEW intersection installations, in the absence of
city or other local specifications, Campbell Company
recommends IMSA 14 Gauge (loop detector wire)
18 Gauge 4 Conductor
shielded cable
(12VDC Low voltage
Connection)
Guardian Wiring Connections 12 VDC
Document 906-0026 Rev D
/