2. Danfoss
  3. TS2A
TS2A

Danfoss TS2A Installation guide

  • Hello! I have reviewed the Danfoss TS2A Electronic Air Temperature Sensor installation guide. This document provides key information on the sensor's installation, including optimal placement and wiring guidelines, as well as safety instructions. I'm ready to help with any questions you might have about this device.
  • What is the maximum terminal size for the screw terminals?
    What is the ball pressure test rating?
    Where should the sensor not be situated?
    Who should install the device?
    At what level should the sensor be installed?
AN457331476084en-000101| 1
© Danfoss Climate Solutions | 2023.07
TS2A
Electronic Air Temperature Sensor
Installation Guide
TS2A
When xing the sensor to the wall take care
to note the following:
• Do not situate sensor above a radiator
• Do not situate sensor in direct sunlight
• Fix sensor to wall at eye level
Wiring
Location
TS2A Sensor TPOne-B, M, RF
A B S1 S2
TS2A
25mm
60mm
44mm
This device may only be installed by a qualied electrician in accordance with the wiring diagram, the existing safety
regulations must be observed
Electrical connection
Screw terminals: maximum terminal 2.5mm
Ball pressure test: 75°C
Pollution degree: 2
/