Kuzco Lighting PD85124 Ceiling LED Pendant Operating instructions

Type
Operating instructions
INSTALLATION SHEET
PD85124
Ceiling LED Pendant
START FROM HERE
1a.
1b.
1c.
2a. 2f.
2g.
1e.
1. Remove fixture from its original package
2. Separate mounting plate (1c) from canopy (2a) by
removing canopy screws (2f)
3. Attach mounting plate (1c) to electrical junction box (1a)
using screws provided (1e) in hardware package
4. Secure mounting plate (1c) to mounting surface
with anchors (1f) and screws (1h)
5. To change fixture height, push and hold wire gripper
(2g), slide wire to desired length and then release wire
gripper (2g) to secure
6. Make proper electrical connections (black to hot “L”,
white to neutral “N”, ground to “GND”) with wire nuts
(1b) provided in hardware package
7. Attach canopy (2a) to mounting plate (1c) with canopy
screws (2f)
8. Fine tone wire length if necessary, by push and hold
wire gripper (2g) and then adjust wire to desired length
1f.
1h.
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your fixture installed by a qualified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all time during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
20220323
Please Note:
• This Kuzco LED fixture comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary
contact with the module could cause permanent damage
• Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
• 120V input
  • Page 1 1

Kuzco Lighting PD85124 Ceiling LED Pendant Operating instructions

Type
Operating instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI