RTS Alp-600b User manual

Type
User manual
INSTRUCTION MANUAL
General Description
The ALP-600 Antenna Bracket Kit is a
configuration of aluminum brackets with
mounting hardware used to securely hold the
ALP-600 Telescoping Antenna Mast.
The Universal Stadium Mounting Plate, (Figure 1)
can be mounted vertically or horizontally
depending upon the object in which it is mounted
to. The Antenna Mast Bracket Assembly, (Figure
2) then easily attaches to the previously mounted
plate by turning the hand knobs until tight.
Components
Universal Stadium Antenna Mounting Plate
Antenna Mast Bracket Assembly
Antenna Bracket Hardware Kit
2 - U-bolts 4 - Hex Nuts
4 - Flat and Lock washers 2 - Lag Screws
4 - Wing Nuts
-1-
ALP-600
ANTENNA BRACKET KIT
Order No. 878898
PN 801546 Rev C
8601 East Cornhusker Highway, Lincoln, NE 68507
TELEX COMMUNICATIONS, INC.
Figure 1
Universal Stadium Mounting Plate
Figure 2
Antenna Mast Bracket Assembly
Antenna Mast Bracket Assembly
Assembly
Insert hand knob with 3/8" flat washer into
antenna mast bracket assembly, see Figure 3.
Insert retaining ring into groove on hand knob under
loop strap on antenna mast bracket, see Figure 4.
Repeat following step for remaining hand knob.
-2-
BRACKET
HAND KNOB
RETAINING RING
WASHER
FINAL ASSEMBLY
Figure 3 Figure 4 Figure 5
Universal Stadium Mounting Plate and
Antenna Mast Bracket Assembly
-3-
CENTER LINE
MOUNTING
HOLES
CENTER LINE
MOUNTING
HOLES
MOUNTING
HOLES
MOUNTING
HOLES
Vertical
Mounting
Horizontal
Mounting
Figure 6
Mounting Holes
Hole alignment will be off center to right side. Hole alignment will be off center to left side.
U-clamps or lag screws may be used
for permanent mounting
PRINTED IN U.S.A..
Copyright© 2008 by Telex
TELEX COMMUNICATIONS, INC.
All rights reserved
JAN. 2008
-4-
Figure 7
Mounting Suggestions
Vertical
Horizontal
Table
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

RTS Alp-600b User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI