Ivation IVATSPT15 User manual

Type
User manual

This manual is also suitable for

HEAVY DUTY TRIGGER
START PROPANE TORCH
USER GUIDE
IVATSPT15 (Short-Neck)
IVATSPT30 (Long-Neck)
Thank you for purchasing the Ivation®
Heavy-Duty Trigger Start Propane Torch. This
User Guide is intended to provide you with
guidelines to ensure that operation of this
product is safe and does not pose risk to the
user. Any use that does not conform to the
guidelines described in this User Guide may
void the limited warranty.
Please read all directions before using the
product and retain this guide for reference.
This product is intended for domestic use
only. It is not intended for commercial use.
This product is covered by a limited one-year
warranty. Coverage is subject to limits and
exclusions. See warranty for details.
WARRANTY
INFORMATION
LIMITED WARRANTY ON IVATION®
HEAVY-DUTY TRIGGER START
PROPANE TORCH
THIS LIMITED WARRANTY GIVES YOU SPECIFIC
LEGAL RIGHTS AND YOU MAY ALSO HAVE OTHER
RIGHTS, WHICH VARY FROM STATE TO STATE.
WE WARRANT THAT DURING THE WARRANTY
PERIOD, THE PRODUCT WILL BE FREE FROM
DEFECTS IN MATERIALS AND WORKMANSHIP.
LIMITATION OF LIABILITY
TO THE EXTENT NOT PROHIBITED BY LAW, THIS
WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL
OTHER WARRANTIES, ORAL, WRITTEN, STATUTORY,
EXPRESS OR IMPLIED. EXCEPT FOR THE EXPRESS
WARRANTIES CONTAINED IN THIS LIMITED
WARRANTY STATEMENT AND TO THE EXTENT NOT
PROHIBITED BY LAW, WE DISCLAIM ALL OTHER
WARRANTIES, EXPRESSED OR IMPLIED, STATUTORY
OR OTHERWISE, INCLUDING WITHOUT LIMITATION,
THE WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE. SOME
STATES DO NOT ALLOW DISCLAIMERS OF IMPLIED
WARRANTIES, SO THIS DISCLAIMER MAY NOT
APPLY TO YOU. TO THE EXTENT SUCH WARRANTIES
CANNOT BE DISCLAIMED UNDER THE LAWS OF
YOUR JURISDICTION, WE LIMIT THE DURATION AND
REMEDIES OF SUCH WARRANTIES TO THE DURA-
TION OF THIS EXPRESS LIMITED WARRANTY.
OUR RESPONSIBILITY FOR DEFECTIVE GOODS IS
LIMITED TO REPAIR, REPLACEMENT OR REFUND AS
DESCRIBED BELOW IN THIS WARRANTY STATE-
MENT.
WHO MAY USE THIS WARRANTY? C&A Marketing,
Inc. located at 114 Tived Lane East, Edison, NJ (“we”)
extend this limited warranty only to the consumer who
originally purchased the product (“you”). It does not
extend to any subsequent owner or other transferee of
the product.
WHAT DOES THIS WARRANTY COVER? This limited
warranty covers defects in materials and workmanship
of the Ivation® Heavy-Duty Trigger Start Propane Torch
(the “product”) for the Warranty Period as defined
below.
WHAT DOES THIS WARRANTY NOT COVER? This
limited warranty does not cover any damage due to: (a)
transportation; (b) storage; (c) improper use; (d) failure
to follow the product instructions or to perform any
preventive maintenance; (e) modifications; (f)
unauthorized repair; (g) normal wear and tear; or (h)
external causes such as accidents, abuse, or other
actions or events beyond our reasonable control.
WHAT IS THE PERIOD OF COVERAGE? This limited
warranty starts on the date of your purchase and lasts
for one year (the “Warranty Period”). The Warranty
Period is not extended if we repair or replace the
product. We may change the availability of this limited
warranty at our discretion, but any changes will not be
retroactive.
WHAT ARE YOUR REMEDIES UNDER THIS
WARRANTY? With respect to any defective product
during the Warranty Period, we will, at our sole
discretion, either: (a) repair or replace such product (or
the defective part) free of charge or (b) refund the
purchase price of such product if an exchange unit
cannot be provided.
HOW DO YOU OBTAIN WARRANTY SERVICE? To
obtain warranty service, you must contact us at
1-866-849-3049 or by email at info@myivation.com
during the Warranty Period to obtain a Defective
Merchandise Authorization (“DMA”) number. No
warranty service will be provided without a DMA
number and return shipping costs to our facilities shall
be assumed by you, the purchaser. Shipping costs of
the replacement unit to you shall be assumed by us.
QUESTIONS OR PROBLEMS?
CONTACT US!
info@myivation.com | 1-866-849-3049
IVATION is a trademark of C&A IP Holdings, LLC in the US,
Canada, China and the EU.
All other products, brand names, company names, and logos
are trademarks of their respective owners, used merely to
identify their respective products, and are not meant to
connote any sponsorship, endorsement or approval.
Distributed by C&A Marketing, Inc., 114 Tived Lane East,
Edison, NJ 08837
Made in China.
© 2019. C&A IP Holdings, LLC. All Rights Reserved.
On Off
USING YOUR TORCH
IN COLD WEATHER
In cold weather, the size of the flame might be
smaller due to lower gas pressure. To produce a
larger flame, you can pre-warm the gas cylinder by
bringing it inside or wrapping it in a blanket until it
reaches room temperature prior to use. (Do not
use a heater or an open flame to warm the cylinder.)
Shaking the gas cylinder a few times to warm the
fuel up will also help. There is a possibility that the
flame will extinguish in cold weather conditions.
SHUTTING OFF
YOUR TORCH
1. To extinguish the torch, turn the gas
adjustment knob all the way to the "OFF"
position. The flame may continue for a
short amount of time but should extinguish quickly.
2. When the torch has cooled, turn the gas cylinder
clockwise to disconnect it. Pull slightly on the
ignition button to vent the remaining gas inside
the torch.
CARE AND
MAINTENANCE
1. Do not clean the burner tube immediately after
turning the flame o. Put it in a cool, dry location
for about 10-15 minutes after use. Make sure it is
completely cooled, then use a wet towel to
clean it.
2. Any other servicing should be performed by an
authorized service representative.
3. Do not put the torch in water or it will not
function correctly.
4. Always store the torch in a cool, dry area to avoid
a product malfunction or any O-rings breaking.
5. Always store the torch and gas cylinders
separately. Make sure to read other warnings on
the gas cylinder label regarding storage
and disposal.
678
USING YOUR TORCH
Trigger-start propane torch
• User guide
Burner tube
Short-Neck Torch (IVATSPT15)
DANGER: EXTREMELY FLAMMABLE. CONTENTS
UNDER PRESSURE.
• Don’t use this torch until you thoroughly read and
understand all of the operation instructions and
warnings. Deviating from these instructions could
result in fire, explosions, property damage, and/or
operator injury. Don’t try to operate this device
without reading the instructions.
• Make sure to familiarize yourself with the appliance
itself before using it.
• Don’t use any fuel other than propane with this torch,
or else it could result in fires, explosions, property
damage, and/or operator injury.
• Always close the torch valve and wait for the torch to
cool down before tightening or removing the torch
head, and before installing or removing accessories.
Failure to do so could result in severe burns.
• Before using this appliance, check all the parts to
make sure they function properly, and make sure no
components have been damaged.
• Keep the torch out of the reach of children.
• Always keep away from heat or flame, and avoid
prolonged exposure to sunlight.
• Disconnect the propane cylinder when this torch is
not in use. Never store the torch while it’s attached to a
propane tank.
• Do not store the torch and/or propane tank near
heat or in a room used for habitation.
• Don’t use this torch to heat, mold, or bend plastic
sheets, molding, or tubing.
• Don’t use this torch to remove paint.
• Never point the torch toward your face, other people
(or their faces), animals, or any other flammable
objects/persons. Please never attempt to use this
torch as a cigarette lighter.
• Do not attach or detach the torch from the gas
cylinder in an area where accidentally released gas
might be ignited by open flames.
• Never attempt to modify the torch construction and
never use unapproved fuel, or else it could result in
fires, explosions, property damage, and/or operator
injury.
• Don’t use a leaking, damaged, or malfunctioning
torch.
• Treat this torch as you would any fine tool or
instrument. If it’s ever damaged, do not use it, and
immediately contact the authorized service center for
assistance.
• Torches improperly operated, maintained, or
repaired are dangerous! Improper use, service repair,
or modification of the torch could result in damage to
the product, property damage, or personal injury to
the operator.
• When the gas cylinder is empty, dispose of it
properly in a safe and approved location. Do not
throw the cylinder into a fire, puncture, or incinerate it.
• It is illegal and dangerous to refill the propane gas
tank on your own. Obtain a new propane cylinder
from an authorized retailer.
• Do not inhale gas, fumes, vapor, or spray from the
propane cylinder or torch, and avoid contact with skin
and eyes. If inhaled, immediately move the aected
person to fresh air. For skin contact, flush with lots of
water. In case of eye contact, rinse immediately with
plenty of water and then seek medical advice.
• Always place your work on firebrick. Ordinary brick
and concrete can explode when subjected to high
temperatures. Do not work on wood or metal surfaces
with this product. Always shield your work.
• Always wear protective glasses and gloves. Use
proper tools to handle hot work. Always have a fire
extinguisher and a bucket of water near your torch
and work area.
• Only use this torch in well-ventilated areas.
• Hidden areas such as those behind walls, ceilings,
floors, sot boards, and other panels may contain
flammable materials that could be ignited by the heat
gun when working in these locations. The ignition of
these materials may not be readily apparent and
could result in property damage and injury to persons.
• When working in locations that could have hidden
areas/flammable materials behind them, keep the
torch moving in a back-and-forth motion. Lingering or
pausing in one spot could ignite the panel or the
material behind it.
DON’T CHANGE THE BURNER TUBE WHEN THE
GAS CYLINDER IS STILL CONNECTED TO THE TORCH.
DON’T TURN THE BURNER TUBE FORCEFULLY
AFTER LOCKING IT INTO PLACE.
SAFETY PRECAUTIONS PRODUCT OVERVIEW
PACKAGE CONTENTS
On Off
On Off
Burner tube
Ignition
button
Gas
adjustment
knob
Gas adjustment
knob
Handle
Handle
Propane
connector
Ignition
button
1. This torch should only be used with a CGA
600 handle propane cylinder tank or US 1"
threaded valve.
2. Before installing the torch on the gas cylinder,
make sure the valve is OFF by turning the gas
adjustment knob in a clockwise direction until
it’s securely hand-tightened. DO NOT FORCE IT.
3. Hold the torch and gas cylinder upright. Turn
the cylinder counter-clockwise into the torch
valve body until it’s securely hand-tightened
and attached to the torch connection. Do not
force it. Check the connection to ensure there
are no leaks. See below for instructions.
4. Turn the gas adjustment
knob counter-clockwise
until you hear a slight
hissing sound (this indicates
gas is flowing). Press the
ignition button to produce
a ame.
ADJUSTING THE FLAME
1. Turn the adjustment knob to control the gas
output and the size of the flame.
2. The maximum heat zone is very concentrated.
It’s located between ½" to 1" (1.32.5 cm) from
the end of the tip. Holding the torch too close or
too far away from the target can reduce the
heating eect.
HOW TO CHECK
FOR LEAKS
1. Apply soapy water to the connection.
2. Slowly open the gas
adjustment knob and
watch for bubbles.
3. If bubbles appear, close
the gas adjustment valve
and tighten connections
immediately (but do not
over tighten).
4. Repeat steps 1 through 3 until the bubbles stop.
2345
  • Page 1 1
  • Page 2 2

Ivation IVATSPT15 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI